my 08 gt500 slow make over.
04-04-2012, 12:10 AM
#1
2nd Gear Member
Thread Starter
Join Date: Dec 2011
Location: california
Posts: 377
my 08 gt500 slow make over.
everything stock
new rims stance sc5
lowered with eibach coilovers
added new cross drilled slotted rotors
window louvers
new antena 8"
JLT lower grill bezels
what she looks like now!
new rims stance sc5
lowered with eibach coilovers
added new cross drilled slotted rotors
window louvers
new antena 8"
JLT lower grill bezels
what she looks like now!
Last edited by BlackShelbyGt500; 04-04-2012 at 12:12 AM.
04-04-2012, 09:59 AM
#5
3rd Gear Member
Join Date: Nov 2006
Location: Texas
Posts: 977
they are the cooling duct inserts for the front brakes when they are functional. The KR's have these. I thought about maybe getting these for the front as well.
Looking good! What does the rear look like? Have you centered the rear Shelby badge yet?? this is a must have as well! Smoke the tails, front signals and rear markers as well
Looking good! What does the rear look like? Have you centered the rear Shelby badge yet?? this is a must have as well! Smoke the tails, front signals and rear markers as well
04-04-2012, 11:07 AM
#6
4th Gear Member
Join Date: Apr 2008
Location: North Idaho
Posts: 1,440
I ran 2.5" tubing from my brake vents...drivers side comes up right under the air filter and the other side blows straight up into the engine bay toward the blower...really increases the outside air flow through the engine and cold air directly to the filter...
04-04-2012, 12:19 PM
#7
2nd Gear Member
Thread Starter
Join Date: Dec 2011
Location: california
Posts: 377
I haven't centered the shelby badges, did you used the stock shelby lettering in the rear? If you did have did you take it off and what did you use to stick them in there? Also my billet hoods pins kits should be here by the end of the day, so im going to be installing those and on thursday my side scoop should be installed also.
Last edited by BlackShelbyGt500; 04-04-2012 at 12:26 PM.
04-04-2012, 02:59 PM
#9
3rd Gear Member
Join Date: Nov 2006
Location: Texas
Posts: 977
I haven't centered the shelby badges, did you used the stock shelby lettering in the rear? If you did have did you take it off and what did you use to stick them in there? Also my billet hoods pins kits should be here by the end of the day, so im going to be installing those and on thursday my side scoop should be installed also.
04-04-2012, 06:50 PM
#10
2nd Gear Member
Thread Starter
Join Date: Dec 2011
Location: california
Posts: 377
I reused mine since it's the "red stripe edition" lettering with the red inserts... you can order a center badge template off of ebay for like $20 i think, that's the route I went. Get some goo-gone and some dental floss and go to work. Have a razor blade handy for taking the excess tape off the letters after removal. It also makes it easier to heat up the surface with a blow-dryer or something. Good luck!
