Throttle body cables.
#1
Throttle body cables.
OK, so I recently installed a Series IV S/C to upgrade from the Series I on my 2000. I ran into a little snag. One of the two throttle cables wont reach to attach to the throttle body.
The one that doesn't reach is the one that snaps on to the T/B. The accelerator cable reaches fine but the old bracket is not the same as the Series IV, I think.
Here's my question: What is that non accelerator cable for and how can I adjust/pull out of the firewall/fender about 2" more so it can reach the T/B?
Edit:Is that other cable for cruise control? If it is, is it easy to adjust?
Crappy cell phone pic included.
Thanks for any help.
The one that doesn't reach is the one that snaps on to the T/B. The accelerator cable reaches fine but the old bracket is not the same as the Series IV, I think.
Here's my question: What is that non accelerator cable for and how can I adjust/pull out of the firewall/fender about 2" more so it can reach the T/B?
Edit:Is that other cable for cruise control? If it is, is it easy to adjust?
Crappy cell phone pic included.
Thanks for any help.
Last edited by 00 425 SALEEN; 12-10-2008 at 11:08 AM.
#2
Yes, it is for the cruise. Saleen used one from another model.....possibly 99-01 cobra?? I can't remember.
And they did use another style mounting bracket for the series 4. See pic in link
http://www.haneymotorsport.com/salee...to4Upgrade.jpg
Casey
And they did use another style mounting bracket for the series 4. See pic in link
http://www.haneymotorsport.com/salee...to4Upgrade.jpg
Casey
Last edited by HaneyMotorsport.Com; 12-10-2008 at 05:46 PM.
Thread
Thread Starter
Forum
Replies
Last Post