Search

Go Back   MustangForums.com > Search Forums
Sign in using an external account
Register Forgot Password?
Search

Welcome to Mustang Forums!
Welcome to Mustang Forums.

You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!


Showing results 1 to 25 of 497
Search took 4.63 seconds.
Search: Posts Made By: jwog666
Forum: Speed Density/Carb/SSP section 06-29-2011, 04:08 PM
Replies: 11
Views: 1,161
Posted By jwog666
what else have you done to the engine? if all you...

what else have you done to the engine? if all you did was rip off the efi and bolt on a double pumper the bog is most likely being caused by the massive ammount of fuel being pumped in by the twin...
Forum: Mustang News, Concepts, Rumors & Discussion 06-29-2011, 04:00 PM
Replies: 1
Views: 331
Posted By jwog666
im confused, how do you know you have spark if it...

im confused, how do you know you have spark if it wont crank? is this a crank/no start or a no crank/no start? what control module, pcm, tfi? whats the fuel pressure?
Forum: V6 General Discussion 06-29-2011, 03:52 PM
Replies: 3
Views: 296
Posted By jwog666
the fan is grounded at the rh side of the engine...

the fan is grounded at the rh side of the engine compartment, the ground will be a ring terminal bolted to the sheet metal somewhere. the ccrm is fine if its supplying power. since your problem is...
Forum: General Tech 06-29-2011, 03:44 PM
Replies: 2
Views: 380
Posted By jwog666
it is my understanding that the heads are a...

it is my understanding that the heads are a different design that employs a spark plug with threads that go all the way down, and that this started late 08 or early 09.
Forum: V6 (1994-2004) Mustangs 06-29-2011, 03:31 PM
Replies: 3
Views: 568
Posted By jwog666
your system is low on refrigerant, it need to be...

your system is low on refrigerant, it need to be recovered and recharged. i have a chart that tells you compressor on time based on ambient air temp somewhere, but 1 sec. of compressor on time is way...
Forum: 2005 - 2014 Mustangs 06-28-2011, 03:24 PM
Replies: 6
Views: 2,685
Posted By jwog666
if the motorhousing you bought from ford was...

if the motorhousing you bought from ford was purchased recently you may be able to warranty it if that is the problem.
Forum: 2005 - 2014 Mustangs 06-28-2011, 03:00 PM
Replies: 6
Views: 2,685
Posted By jwog666
i dont have experience with the bbk tb, but im...

i dont have experience with the bbk tb, but im guessing that the motorhousing swaps from the ford tb to the bbk tb? if so the problem is most likely going to be in the motor not the actual throttle...
Forum: Mach 1 Section 06-28-2011, 02:37 PM
Replies: 4
Views: 1,153
Posted By jwog666
+ 1 on octane booster being crap. also, new plugs...

+ 1 on octane booster being crap. also, new plugs already come coated with corrosion inhibitor and dont require any additional anti-seize.
Forum: 2005 - 2014 Mustangs 06-28-2011, 02:30 PM
Replies: 6
Views: 2,685
Posted By jwog666
P061B - Internal Control Module Torque...

P061B - Internal Control Module Torque Calculation PerformanceDescription:Indicates a calculation error occurred in the powertrain control module (PCM). This DTC is set in combination with...
Forum: 4.6L V8 Technical Discussions 06-28-2011, 01:35 PM
Replies: 9
Views: 633
Posted By jwog666
in my opinion the spacers do anything but make...

in my opinion the spacers do anything but make weird whistling noises
Forum: 4.6L General Discussion 06-28-2011, 01:32 PM
Replies: 4
Views: 1,644
Posted By jwog666
yes its lower down below the coil packs, you are...

yes its lower down below the coil packs, you are very close just look a little closer.

here is a pic but you will need to zoom in a bit, sorry its line art.
Forum: V6 (1994-2004) Mustangs 06-28-2011, 01:24 PM
Replies: 7
Views: 1,380
Posted By jwog666
the transmission shifting problem may be caused...

the transmission shifting problem may be caused by the vss reading so far off. if you are going 30 and the car thinks you are going 80 the trans will shift all sorts of crazy. this may be caused by a...
Forum: 4.6L (1996-2004 Modular) Mustang 06-27-2011, 04:00 PM
Replies: 6
Views: 3,083
Posted By jwog666
do you have power on the dg/o (dark green with an...

do you have power on the dg/o (dark green with an orange stripe) wire coming out of the high pressure switch with everything plugged in and the ac turned on? you must back probe the connector with a...
Forum: V6 (1994-2004) Mustangs 06-27-2011, 03:44 PM
Replies: 7
Views: 1,380
Posted By jwog666
you cant just switch the pcm's due to the pats...

you cant just switch the pcm's due to the pats antitheft. sounds like the wrecked trans you swapped into the vehicle may actually be wrecked. any codes?
Forum: 4.6L General Discussion 06-27-2011, 03:39 PM
Replies: 4
Views: 1,644
Posted By jwog666
mine used to throw that code when the temps were...

mine used to throw that code when the temps were above 85, replace the sensor = fixed. the sensor is located on the left hand side of the engine front cover, one bolt holds it in place. its a 5 min...
Forum: 4.6L (1996-2004 Modular) Mustang 06-27-2011, 03:33 PM
Replies: 4
Views: 290
Posted By jwog666
napa says it all, i have had bad luck with napa...

napa says it all, i have had bad luck with napa alternators and have had to replace some as many as 4 times in 1 years time. i would return the alt. get my money back anf purchase one from a...
Forum: 2005 - 2014 Mustangs 06-25-2011, 05:40 PM
Replies: 3
Views: 1,267
Posted By jwog666
DescriptionThe powertrain control module (PCM)...

DescriptionThe powertrain control module (PCM) flagged a concern indicating that throttle position (TP) 1 and TP2 disagree by more than a calibrated limit.
Possible CausesTP sensor shorted...
Forum: 5.0L V8 Technical Discussions 06-23-2011, 01:55 PM
Replies: 9
Views: 3,772
Posted By jwog666
if its a canned tune you should have no problems....

if its a canned tune you should have no problems. im a ford tech and unless we know for sure that the ford part that failed was caused by your tune it will be covered. that being said, i have never...
Forum: SVT Forums 06-23-2011, 12:27 PM
Replies: 8
Views: 750
Posted By jwog666
i would say the connector is at fault. your 96...

i would say the connector is at fault. your 96 cobra takes r12? i thought that they had switched to r134a by then. also make sure you add more oil to replace what you nhave lost.
Forum: SVT Forums 06-23-2011, 12:12 PM
Replies: 8
Views: 750
Posted By jwog666
if your compresor has failed the system should be...

if your compresor has failed the system should be flushed along with all the parts you have replace to remove any debris. if you didnt flush the system this is most likely the cause of your repeat...
Forum: V6 (1994-2004) Mustangs 06-15-2011, 04:25 PM
Replies: 5
Views: 2,808
Posted By jwog666
if its a windstar check the air inlet tube...

if its a windstar check the air inlet tube between the throttle body and air filter housing on the back side of the tube, there is a plastic breather tube. its hard to see and easy to forget to...
Forum: 4.6L (1996-2004 Modular) Mustang 06-09-2011, 01:33 PM
Replies: 11
Views: 15,224
Posted By jwog666
if the system leaked and air got in it wont...

if the system leaked and air got in it wont operate properly and the pressures will be off. the only proper way to recharge a system is to recover any refrigerant that may be in the system, pull a...
Forum: 4.6L (1996-2004 Modular) Mustang 06-09-2011, 01:00 PM
Replies: 24
Views: 1,745
Posted By jwog666
the switch should be under the left side trunk...

the switch should be under the left side trunk liner at the left quarter panel. not sure if the wires pictured are the correct one.
Forum: 4.6L (1996-2004 Modular) Mustang 06-07-2011, 06:07 PM
Replies: 11
Views: 15,224
Posted By jwog666
if you jump it and there is no power going to the...

if you jump it and there is no power going to the switch it still wont turn on. you need to be checking for power and ground at the switch with the ac turned on.
Forum: 4.6L (1996-2004 Modular) Mustang 06-07-2011, 02:33 PM
Replies: 11
Views: 15,224
Posted By jwog666
is there enough refrigerant in the system to make...

is there enough refrigerant in the system to make it operate properly? check the fuse for the compressor, check the relay. most of the time they wont turn on due to a low charge.
Showing results 1 to 25 of 497

 
Forum Jump
Advertising

Featured Sponsors
Vendor Directory
New Sponsors
All times are GMT -5. The time now is 02:10 AM.

© Internet Brands, Inc.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.

This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company
Emails Backup