Go Back   MustangForums.com > Search Forums
Sign in using an external account
Register Forgot Password?
Search


Welcome to Mustang Forums!
Welcome to Mustang Forums.

You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!


Showing results 1 to 25 of 487
Search took 0.57 seconds.
Search: Posts Made By: Archion
Forum: V6 (1994-2004) Mustangs 05-15-2015, 06:13 PM
Replies: 5
Views: 143
Posted By Archion
Yeah, I just looked again, I could not get a good...

Yeah, I just looked again, I could not get a good picture because my phone is crap, but the above layout is correct. lugwrench lays across to the rear of the car, under the tire.
Forum: V6 (1994-2004) Mustangs 05-15-2015, 01:53 PM
Replies: 2
Views: 106
Posted By Archion
Stock is nothing greaseable. Sealed units from...

Stock is nothing greaseable. Sealed units from the factory.
Forum: V6 (1994-2004) Mustangs 05-14-2015, 12:24 PM
Replies: 5
Views: 143
Posted By Archion
IIRC, There is a mat on the floor of the trunk,...

IIRC, There is a mat on the floor of the trunk, the jack goes in the middle under the tire with the jbolt going through it. lug wrench is off to the side, but still kept down by the tire, then the...
Forum: V6 (1994-2004) Mustangs 05-14-2015, 11:18 AM
Replies: 5
Views: 197
Posted By Archion
Yeah, it doesn't come out easily unless you have...

Yeah, it doesn't come out easily unless you have the console out. When I bypassed mine back in 2000, I just unplugged the harness and used the bypass cable. It wasn't until I put in new carpet after...
Forum: V6 (1994-2004) Mustangs 05-14-2015, 11:16 AM
Replies: 5
Views: 143
Posted By Archion
I'll try and remember to get a pic for you when I...

I'll try and remember to get a pic for you when I get home tonight.
Forum: V6 (1994-2004) Mustangs 05-01-2015, 03:30 PM
Replies: 4
Views: 154
Posted By Archion
Yeah. Mine was just tossed in.

Yeah. Mine was just tossed in.
Forum: V6 (1994-2004) Mustangs 04-30-2015, 01:55 PM
Replies: 4
Views: 154
Posted By Archion
usually down with the spare tire, tucked beside...

usually down with the spare tire, tucked beside it.
Forum: V6 (1994-2004) Mustangs 04-29-2015, 04:53 PM
Replies: 5
Views: 197
Posted By Archion
You are far better off to bypass the factory amp....

You are far better off to bypass the factory amp. It does not pass all audio frequencies to the rear speakers, and the fronts will sound muddy at best.
Forum: V6 (1994-2004) Mustangs 04-29-2015, 04:09 PM
Replies: 0
Views: 111
Posted By Archion
Finally dving in - Manual Swap

I've been wanting to do this for a while, patiently waiting until I could score a donor car for the right price. Now I have one. I picked up a 99 V6 5spd for dirt cheap. It's a Cali car, plus mine...
Forum: V6 (1994-2004) Mustangs 04-29-2015, 03:42 PM
Replies: 5
Views: 197
Posted By Archion
It is on top of the transmission tunnel, at the...

It is on top of the transmission tunnel, at the base of the dash, near the firewall at very front of the console. When you unplug it, the output harness will actually match the stereo adapter harness.
Forum: V6 General Discussion 06-05-2009, 09:21 AM
Replies: 1
Views: 180
Posted By Archion
This Weekend's event...

Any one going to Carlisle this weekend??

http://www.carlisleevents.com/ce/events/ford-nationals/

All Ford Nationals, I'll be up there Saturday, I only live 45 minutes from there. I'll have my...
Forum: V6 General Discussion 05-14-2009, 01:12 PM
Replies: 22
Views: 1,031
Posted By Archion
My bad, mine has bolts, but the same principle...

My bad, mine has bolts, but the same principle applies, drill the new holes in the spoiler and screw the bolts in to the new holes, it is a very coarse thread, like self tapping. You should be able...
Forum: V6 (1994-2004) Mustangs 05-14-2009, 01:07 PM
Replies: 10
Views: 752
Posted By Archion
Did you swap the board? (PATS Module)

Did you swap the board? (PATS Module)
Forum: V6 (1994-2004) Mustangs 05-14-2009, 01:06 PM
Replies: 3
Views: 268
Posted By Archion
Replace the multi-function switch,...

Replace the multi-function switch, wipers/turns/etc are all controlled through this switch.

http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=SW5605%20%20%20%20%20%20%20%20%201&comp=LRS
Forum: V6 (1994-2004) Mustangs 05-14-2009, 09:33 AM
Replies: 2
Views: 523
Posted By Archion
Not the entire dash, just the gauge cluster, not...

Not the entire dash, just the gauge cluster, not too bad at all really. Just a handful of screws.
Forum: V6 General Discussion 05-13-2009, 02:49 PM
Replies: 22
Views: 1,031
Posted By Archion
On that write up, when I moved mine, i did not...

On that write up, when I moved mine, i did not drill any new holes on the truNck lid, I moved the studs in the spoiler itself, in case I ever wanted to move it again.
Forum: V6 General Discussion 05-13-2009, 02:44 PM
Replies: 70
Views: 6,695
Posted By Archion
160K On my 99, I put 60k on the 06 in a year...

160K On my 99, I put 60k on the 06 in a year before I traded it on the Focus last year, which now has 56k on it... Yeah I drive a lot these days...
Forum: V6 General Discussion 05-11-2009, 02:51 PM
Replies: 22
Views: 1,031
Posted By Archion
Looks good, I didn't move mine back quite that...

Looks good, I didn't move mine back quite that far, I only went back two inches, that way the body lines still kinda match up.

You can kinda see it in these pics...
...
Forum: V6 (1994-2004) Mustangs 05-08-2009, 08:07 PM
Replies: 7
Views: 268
Posted By Archion
Looks like an error in listing, they are the same...

Looks like an error in listing, they are the same unit...

http://www.blueovalindustries.com/products.php?pid=99013193
Forum: V6 (1994-2004) Mustangs 05-07-2009, 03:50 PM
Replies: 6
Views: 466
Posted By Archion
Just get their heavy duty non adjustable unit, it...

Just get their heavy duty non adjustable unit, it takes the place of the stock sway bar.

http://www.steeda.com/products/hd_rear_sway_bar.php
Forum: V6 (1994-2004) Mustangs 05-05-2009, 08:57 PM
Replies: 7
Views: 268
Posted By Archion
I'm not big on the chrome, but everything I have...

I'm not big on the chrome, but everything I have ever bought from Blue Oval has been good.
Forum: V6 (1994-2004) Mustangs 05-05-2009, 03:24 PM
Replies: 9
Views: 183
Posted By Archion
You have to pull the outer tie rod to replace it,...

You have to pull the outer tie rod to replace it, do not, repeat, do not buy a "Split Boot", nothing but trouble. If you drive in a dusty area or you are getting this lovely rain that we have on the...
Forum: V6 (1994-2004) Mustangs 05-02-2009, 04:18 PM
Replies: 3
Views: 1,138
Posted By Archion
There is a bearing in the clutch assembly that is...

There is a bearing in the clutch assembly that is replaceable. If you are not familiar with feeler gauges and shims, than you do not need to be pulling the clutch off of a fs/fx series compressor....
Forum: V6 (1994-2004) Mustangs 04-30-2009, 09:00 PM
Replies: 2
Views: 340
Posted By Archion
Here ya go, this should help. You need Acrobat...

Here ya go, this should help. You need Acrobat Reader(PDF).

Airbag Module Service (http://2pony.net/Downloads/StangFiles/airbag.pdf)<---Clicky!!!
Forum: V6 (1994-2004) Mustangs 04-30-2009, 02:40 PM
Replies: 2
Views: 340
Posted By Archion
It's not a plug that he needs, he needs the...

It's not a plug that he needs, he needs the airbag module itself, once the airbags have been fired you need to replace this. If I remember right, it is located on top of the transmission tunnel by...
Showing results 1 to 25 of 487

 
Forum Jump
Advertising

Featured Sponsors
Vendor Directory
New Sponsors
All times are GMT -5. The time now is 01:27 PM.

© Internet Brands, Inc.


This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company
Emails Backup