MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Sign in using an external account
Register Forgot Password?
Search


Showing results 1 to 25 of 56
Search took 0.06 seconds.
Search: Posts Made By: SWGSSSlacker
Forum: 5.0L (1979-1995) Mustang 06-18-2015, 08:25 PM
Replies: 6
Views: 221
Posted By SWGSSSlacker
Your serpentine belt is routed correctly?

Your serpentine belt is routed correctly?
Forum: 5.0L (1979-1995) Mustang 06-18-2015, 06:54 PM
Replies: 8
Views: 278
Posted By SWGSSSlacker
The Smog pump and all of it's piping has been...

The Smog pump and all of it's piping has been removed, vacuum lines plugged.
The cylinder heads have plugs in them where the emissions piping once connected.
The EGR valve and sensor have been...
Forum: 5.0L (1979-1995) Mustang 06-18-2015, 06:43 PM
Replies: 8
Views: 278
Posted By SWGSSSlacker
Ok....ran KOEO and KOER tests. KOEO: 34 ...

Ok....ran KOEO and KOER tests.

KOEO: 34
KOEO: (stored) 18, 34

KOER: 34, 44, 94, 18

Cylinder balance test: 9 and 9 (pass)

TPS is set at .95.
Forum: 5.0L (1979-1995) Mustang 06-12-2015, 07:24 PM
Replies: 8
Views: 278
Posted By SWGSSSlacker
Ok, installed new PiP sensor, checked and reset...

Ok, installed new PiP sensor, checked and reset timing and still have the same issue.

Annoyed in Texas!
Forum: 5.0L (1979-1995) Mustang 06-10-2015, 10:38 PM
Replies: 8
Views: 278
Posted By SWGSSSlacker
Anyone here that can verify what the voltage from...

Anyone here that can verify what the voltage from the PiP sensor (hall effect) is supposed to be running at during normal idle? I've researched and found it's supposed to be between 3-6 volts but...
Forum: 5.0L (1979-1995) Mustang 06-10-2015, 10:25 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
I am not a fan of the Autozone, O'Reilly, etc...

I am not a fan of the Autozone, O'Reilly, etc autoparts stores either but in a pickle I will go to them. I do 98% of my parts shopping at Standard Auto Parts, no not the Standard if the computer...
Forum: 5.0L (1979-1995) Mustang 06-07-2015, 11:04 PM
Replies: 3
Views: 156
Posted By SWGSSSlacker
Is the weep hole on the bottom of the water pump...

Is the weep hole on the bottom of the water pump wet?

Crawl under the car, use a flashlight and look at the bottom of the water pump, there is a designed hole there.....if the area is wet you need...
Forum: 5.0L (1979-1995) Mustang 06-07-2015, 11:54 AM
Replies: 8
Views: 278
Posted By SWGSSSlacker
Annoying stumble

So the car is up and running again with the 3rd purchased ICM. Third time's the charm! I now have a issue at constant cruising speed, say 5th gear, 70 mph at 1750/1800 rpms. The motor will be running...
Forum: 5.0L (1979-1995) Mustang 06-06-2015, 08:58 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
By the way.... Thanks for the help folks.

By the way....

Thanks for the help folks.
Forum: 5.0L (1979-1995) Mustang 06-06-2015, 08:56 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
Well, after researching how to test a ICM and PiP...

Well, after researching how to test a ICM and PiP sensor I have discovered that new parts don't mean squat. I verified the PiP sensor was doing what is was supposed to with the use of a multimeter...
Forum: 5.0L (1979-1995) Mustang 06-05-2015, 09:13 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
I've even insulated/wrapped my distributor and...

I've even insulated/wrapped my distributor and the thermostat housing to try and remove a heat issue from the equation. It did not help!
Forum: 5.0L (1979-1995) Mustang 06-05-2015, 08:59 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
I bought a completely new distributor that had...

I bought a completely new distributor that had all new parts in/on it. I did replace the ICM that came with the distributor with a FOMOCO unit but the PiP sensor is the one that came inside the...
Forum: 5.0L (1979-1995) Mustang 06-05-2015, 08:58 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
The spout connector does advance the timing when...

The spout connector does advance the timing when it is plugged in I'd like to think the ECU is doing what it is supposed to do.

I'm trying to contact my alarm installer to find out what needs to...
Forum: 5.0L (1979-1995) Mustang 06-05-2015, 08:43 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
Disregard my last post! The correct ECU pin...

Disregard my last post!

The correct ECU pin # is 36 for cross checking ohms across the spout circuit. I took the connector cover off of the ECU plug and looked at the wiring, the wire leaving ECU...
Forum: 5.0L (1979-1995) Mustang 06-05-2015, 07:25 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
Ok, I'm pin pointing things and I might finally...

Ok, I'm pin pointing things and I might finally be homing in on my solution.

I have a stored code 18 in my cars brain "loss of TACH signal to Electronic Control Assembly" (ECA). I have found this...
Forum: 5.0L (1979-1995) Mustang 06-04-2015, 06:01 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
How do I know if I have a bad IAC valve or bad...

How do I know if I have a bad IAC valve or bad IAC valve connector?
The car will die when I turn the A/C on...not right away but it will eventually.
I think something is amiss with its operation,...
Forum: 5.0L (1979-1995) Mustang 05-31-2015, 08:14 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
Yes it does, Viper. I bought it because it will...

Yes it does, Viper. I bought it because it will alarm the keypad if someone messes with it.
It also has a kill switch that kills power to the fuel pump relay.
Forum: 5.0L (1979-1995) Mustang 05-31-2015, 07:38 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
Update: Replaced what I believed to be the...

Update:

Replaced what I believed to be the EEC relay (right next to the ECU). I started the engine, it ran for 30 seconds and died out of the blue. I didn't attempt to troubleshoot any further,...
Forum: 5.0L (1979-1995) Mustang 05-31-2015, 06:01 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
Sorry for the delay in responding but I'm still...

Sorry for the delay in responding but I'm still at square one.

After the ECU replacement, re-check of TPS voltage, re-check of timing and firing order the car will still die out of the blue while...
Forum: 5.0L (1979-1995) Mustang 05-19-2015, 03:35 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
No, No replacement to test here but I did order a...

No, No replacement to test here but I did order a new one from Rockauto.com.
It was $227.00 for it but $95.00 of it is a core charge so $132.00 isn't to bad.

It's not a FOMOCO either it's a...
Forum: 5.0L (1979-1995) Mustang 05-19-2015, 03:17 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
Also... Yes it will read KOEO but won't...

Also...

Yes it will read KOEO but won't COMPLETELY read KOER due to the fact that it can't elevate the engine RPMS to perform the EEC test. So I guess it'll read KOER codes because I do get a...
Forum: 5.0L (1979-1995) Mustang 05-19-2015, 03:11 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
The car tested fine and then all the sudden it no...

The car tested fine and then all the sudden it no longer did. I have the same IAC on it now that I did when I was able to EEC test it. I did not unplug the IAC valve at any time nor did I mess with...
Forum: 5.0L (1979-1995) Mustang 05-18-2015, 10:45 PM
Replies: 15
Views: 638
Posted By SWGSSSlacker
I bought and installed this kit. It really...

I bought and installed this kit. It really brought the car to life! Happy with the performance of this kit but ready to set my car on fire now due to it being a PITA! :-)
...
Forum: 5.0L General Discussion 05-18-2015, 08:59 PM
Replies: 15
Views: 445
Posted By SWGSSSlacker
Blasphemy!

Blasphemy!
Forum: 5.0L (1979-1995) Mustang 05-18-2015, 08:50 PM
Replies: 23
Views: 598
Posted By SWGSSSlacker
I realize it isn't really a question but I am...

I realize it isn't really a question but I am looking for information.

1. Can no longer perform KOER tests!
2. Engine dies out of the blue for no apparent reason!
3. Have replaced everything...
Showing results 1 to 25 of 56

 
Forum Jump
 
Advertising
Featured Sponsors
Vendor Directory
New Sponsors
All times are GMT -5. The time now is 08:05 PM.>

© Internet Brands, Inc.


This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company
Emails Backup