MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Sign in using an external account
Register Forgot Password?
Search


Showing results 1 to 25 of 292
Search took 0.46 seconds.
Search: Posts Made By: RedFire281
Forum: 2005 - 2014 Mustangs 07-24-2015, 01:07 PM
Replies: 11
Views: 476
Posted By RedFire281
^^^This. Also, it is important to be aware the...

^^^This. Also, it is important to be aware the DOT 4 fluid is backward compatible but the DOT 3 is not forward compatible. That is, if your car requires DOT 3 then the DOT 4 is simply a higher temp...
Forum: GT S197 General Discussion 05-06-2015, 09:55 PM
Replies: 3
Views: 253
Posted By RedFire281
The reason the wiper arm is so difficult to...

The reason the wiper arm is so difficult to remove is because the spring tension that keeps the wiper pressed against the windshield is a lateral-downward force on the retaining bolt. First, you'll...
Forum: 2005 - 2014 Mustangs 03-24-2015, 09:48 PM
Replies: 6
Views: 259
Posted By RedFire281
Have you tried contacting the folks at the San...

Have you tried contacting the folks at the San Gabriel Valley Mustang Club? I'm sure they have a ton of recommendations in your area. Also, the club has workshops and stuff if you're interested in...
Forum: GT S197 General Discussion 02-13-2015, 09:12 AM
Replies: 10
Views: 626
Posted By RedFire281
The Mustang is a sports coupe and not a luxury...

The Mustang is a sports coupe and not a luxury car. As such, the seat is designed with driver feedback in mind. For the OP the 2014's may only be 'less' uncomfortable than the 2008.
Forum: Want To Buy Ads 10-11-2014, 09:09 PM
Replies: 1
Views: 306
Posted By RedFire281
WTB: Used Autolite HT1 Spark Plugs

I’m pulling my Supercharger for maintenance and returning my engine to stock while the S/C is in the shop. I need HT1 plugs until the S/C comes back but I don’t need new plugs; used plugs in good...
Forum: 4.6L V8 Technical Discussions 08-04-2014, 11:42 AM
Replies: 11
Views: 1,065
Posted By RedFire281
Jim, keep us posted on your progress. The upside...

Jim, keep us posted on your progress. The upside is that your problem is not uncommon on our cars. I had the same issue with EVAP, O2 sensor and O2 sensor heater monitors. I drove about 900 miles,...
Forum: GT S197 General Discussion 05-23-2014, 03:35 PM
Replies: 3
Views: 465
Posted By RedFire281
My understanding is that you can run the HT0s in...

My understanding is that you can run the HT0s in an N/A car BUT you have to re-gap to stock (.045?) which may be problematic because of the solid bridge. The only issue I'm aware of is that the...
Forum: 2005 - 2014 Mustangs 04-11-2014, 08:04 PM
Replies: 14
Views: 757
Posted By RedFire281
Oh, snap! I kinda liked the chrome rings and...

Oh, snap! I kinda liked the chrome rings and stock look. LOL
Forum: 2005 - 2014 Mustangs 04-11-2014, 07:23 PM
Replies: 14
Views: 757
Posted By RedFire281
No particular reason for the change except it was...

No particular reason for the change except it was a newer model year and free. You sound knowledgeable regarding this issue; if I were to keep the HU, what would it take to get the system balanced? ...
Forum: 2005 - 2014 Mustangs 04-11-2014, 06:14 PM
Replies: 14
Views: 757
Posted By RedFire281
I just changed the radio and left the rest of the...

I just changed the radio and left the rest of the system intact. I'll do a speaker walk-around to listen whether I can tell if the subwoofers are getting a handshake from the HU. Good advice,...
Forum: 2005 - 2014 Mustangs 04-11-2014, 10:55 AM
Replies: 14
Views: 757
Posted By RedFire281
Replaced 06 Shaker 500 with 09 model year Shaker

I got a 2009 Shaker 500 from a buddy and changed out the stock Shaker in my 2006 GT. The sound doesn’t seem as deep as my old one. As a matter of fact it sounds ‘tinney’ and a bit lifeless like...
Forum: 2005 - 2014 Mustangs 03-21-2014, 08:43 AM
Replies: 5
Views: 1,395
Posted By RedFire281
In stock form your car does not have a map...

In stock form your car does not have a map sensor. What mods do you have?
Forum: 4.6L V8 Technical Discussions 03-13-2014, 08:31 PM
Replies: 9
Views: 1,104
Posted By RedFire281
Have you checked for any diagnostic trouble codes...

Have you checked for any diagnostic trouble codes (DTC)?
Forum: 2005-2009 S197 Appearance Section 02-26-2014, 07:29 AM
Replies: 95
Views: 11,182
Posted By RedFire281
I know I'm reviving an old thread but can anyone...

I know I'm reviving an old thread but can anyone update me on their experience so far concerning visibility of Fordatude gauges in the daytime with headlights on? I've tried the Stack Racing white...
Forum: 2005-2009 S197 Appearance Section 02-24-2014, 12:35 PM
Replies: 7
Views: 964
Posted By RedFire281
+1. Mine are also lowered more than I like but...

+1. Mine are also lowered more than I like but the random scatter is outrageous. But in the daytime they're purty.
Forum: GT S197 General Discussion 02-09-2014, 12:03 PM
Replies: 4
Views: 503
Posted By RedFire281
The P1270 is set because the PCM is constantly...

The P1270 is set because the PCM is constantly comparing RPM and wheel speed. I see you live in Mass; do you recall starting from a stop in ice, snow or mud? If you did, the PCM may have detected...
Forum: 4.6L V8 Technical Discussions 02-08-2014, 12:08 PM
Replies: 3
Views: 478
Posted By RedFire281
I suspect that the P0135 DTC was caused by your...

I suspect that the P0135 DTC was caused by your battery voltage dropping too low (O2 heater test will fail if current draw is not within a calibrated limit); flooding the engine probably resulted in...
Forum: 2005 - 2014 Mustangs 02-02-2014, 06:47 AM
Replies: 7
Views: 660
Posted By RedFire281
Check Fuse #19 in the SJB (Smart Junction Box -...

Check Fuse #19 in the SJB (Smart Junction Box - passenger side kick panel). Ford uses a slow blow fuse so it might look like it is ok but may not be if you look real closely. Change the fuse anyway...
Forum: 2005-2009 S197 Appearance Section 01-29-2014, 02:38 PM
Replies: 14
Views: 783
Posted By RedFire281
Since this is your first attempt at modding then...

Since this is your first attempt at modding then I admire that you want to start out small. I assume you also don't have much experience turning wrenches or have a lot of tools like ramps, torque...
Forum: 2005-2009 S197 Appearance Section 01-15-2014, 08:07 AM
Replies: 8
Views: 775
Posted By RedFire281
Here's a link and pics from another forum that...

Here's a link and pics from another forum that might help:

http://www.allfordmustangs.com/forums/2569033-post12.html
Forum: S197 Handling Section 01-03-2014, 10:00 AM
Replies: 10
Views: 960
Posted By RedFire281
The two best pieces of advice I've ever gotten...

The two best pieces of advice I've ever gotten regarding suspension work is: Remember the purpose of a bushing is to reduce NVH (noise, vibration, harshness). Whenever you install a part with a...
Forum: 2005 - 2014 Mustangs 01-01-2014, 10:41 PM
Replies: 14
Views: 1,290
Posted By RedFire281
True. I did about the same thing and didn't feel...

True. I did about the same thing and didn't feel any change in the steering. When I went for an alignment I found out they couldn't bring it to spec because my driver front lower control arm was...
Forum: GT S197 General Discussion 11-10-2013, 07:18 PM
Replies: 5
Views: 817
Posted By RedFire281
Start by calling Jim III at www.teamjdm.com and...

Start by calling Jim III at www.teamjdm.com and ask him if he can give you a heads up on the motor and when he sold it (miles on the motor, track time, etc). The seller is a pretty good driver to do...
Forum: 2005-2009 S197 Appearance Section 10-28-2013, 05:16 PM
Replies: 92
Views: 7,683
Posted By RedFire281
I asked the following question in another thread...

I asked the following question in another thread in this sub-forum but have not gotten any definitive answer so I'll ask it in this thread.

"Question for pre-release testers: If a diode or two or...
Forum: 2005-2009 S197 Appearance Section 10-27-2013, 07:43 PM
Replies: 33
Views: 2,528
Posted By RedFire281
Question for pre-release testers: If a diode or...

Question for pre-release testers: If a diode or two or three burns out is there a way to replace the faulty LED strip or is the unit sealed and you'll have to buy a whole unit to replace a faulty...
Showing results 1 to 25 of 292

 
Forum Jump
 
Advertising
Featured Sponsors
Vendor Directory
New Sponsors
All times are GMT -5. The time now is 03:20 AM.>

© Internet Brands, Inc.


This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company
Emails Backup