MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Sign in using an external account
Register Forgot Password?
Search


Showing results 1 to 25 of 216
Search took 0.14 seconds.
Search: Posts Made By: bl817
Forum: 2005 - 2014 Mustangs Yesterday, 07:31 AM
Replies: 2
Views: 135
Posted By bl817
I would point you towards the lower tie rod ends...

I would point you towards the lower tie rod ends or ball joints. get the front end up on ramps if you can and pull on the tie rods and see if there is any play. if you can, remove the wheels and see...
Forum: 4.6L V8 Technical Discussions 08-27-2015, 08:16 PM
Replies: 7
Views: 138
Posted By bl817
if all else fails, you could always cut about...

if all else fails, you could always cut about 1/4" to 3/16" out of the taller bracket, and have it welded back together. most fab shops could do this for a minimal fee. heck, even find a shop with a...
Forum: 4.0L V6 Technical Discussions 08-27-2015, 04:16 PM
Replies: 7
Views: 203
Posted By bl817
good solution, and on the cheap, nice. anything...

good solution, and on the cheap, nice. anything is better than having the drivers side under the flat bottom of bumper.
Forum: 2005 - 2014 Mustangs 08-27-2015, 03:59 PM
Replies: 1
Views: 175
Posted By bl817
i changed my line out to SS and I know the slave...

i changed my line out to SS and I know the slave cylinder clip as a MFER to get to and get out. since your line is already out, I would try and get the clip out and check it. make sure its not spread...
Forum: 4.0L V6 Technical Discussions 08-26-2015, 03:41 PM
Replies: 7
Views: 203
Posted By bl817
also add the cost of a GT rear bumper with dual...

also add the cost of a GT rear bumper with dual cutouts. I think it looks ghetto if just the one side IMHO.
Forum: 2005 - 2014 Mustangs 08-26-2015, 03:26 PM
Replies: 1
Views: 139
Posted By bl817
there is 1 bolt in the middle of each side of the...

there is 1 bolt in the middle of each side of the intake that are on the inside of the runners. find where the fuel rails mount then split that, reach a finger down behind the runner and youll feel a...
Forum: 4.6L V8 Technical Discussions 08-24-2015, 06:32 PM
Replies: 4
Views: 176
Posted By bl817
that's good that there isn't any coolant in the...

that's good that there isn't any coolant in the oil. taking it to a shop is a good idea but you can do some looking with a flashlight and basic hand tools if you feel so inclined. if you take your...
Forum: 4.6L V8 Technical Discussions 08-24-2015, 03:57 PM
Replies: 4
Views: 176
Posted By bl817
i would recommend pulling the intake off and...

i would recommend pulling the intake off and looking around for the leak/s. could be a bad rear main seal or any other seal for that matter. you need to fine the leaks asap and make sure they are...
Forum: 2005 - 2014 Mustangs 08-23-2015, 03:07 PM
Replies: 13
Views: 583
Posted By bl817
have them take care of the plugs if you can talk...

have them take care of the plugs if you can talk them into it. its not a bad job but not fun either. the cowl clip gaskets are another source of water leak. front strut mounts and sway bar end links...
Forum: 4.6L V8 Technical Discussions 08-20-2015, 03:38 PM
Replies: 14
Views: 398
Posted By bl817
alright, well we are throwing possible answers to...

alright, well we are throwing possible answers to help your situation and your not wanting to try any of them. go back to motorcraft plugs, use nickel anti-seize on the snouts only and they will come...
Forum: 2005 - 2014 Mustangs 08-20-2015, 03:14 PM
Replies: 2
Views: 197
Posted By bl817
you will want to use your springs as the gt500 is...

you will want to use your springs as the gt500 is heavier, your car will look like a monster truck with them (ask me how I know). rear upper control arm is same as gt so theres 2 things out....
Forum: GT S197 General Discussion 08-19-2015, 03:39 PM
Replies: 6
Views: 263
Posted By bl817
I would do more reading. most aftermarket TB...

I would do more reading. most aftermarket TB aren't necessary and are plagued with problems. even going to FI, the stocker is more than adequate. id put that money into something else. good luck
Forum: GT S197 General Discussion 08-18-2015, 05:43 PM
Replies: 6
Views: 263
Posted By bl817
what else are you adding to support the TB?

what else are you adding to support the TB?
Forum: 4.6L V8 Technical Discussions 08-17-2015, 05:01 PM
Replies: 14
Views: 398
Posted By bl817
is it throwing any codes while its acting up? I...

is it throwing any codes while its acting up? I would say go back to stock plugs and coil packs and see what happens. why the higher flow injectors? stocks are 19 lbs. any other mods like LT, after...
Forum: S197 Handling Section 08-15-2015, 01:22 PM
Replies: 9
Views: 268
Posted By bl817
theirs is definitely very aggressive as lowering...

theirs is definitely very aggressive as lowering goes. probably has coil overs which will help but once you lower your stocker it will get more harsh. there are lots of combinations out there. I have...
Forum: S197 Handling Section 08-15-2015, 12:02 PM
Replies: 9
Views: 268
Posted By bl817
quite a few meets going on all the time. the...

quite a few meets going on all the time. the north texas mustang club is based in grand prairie and does monthly meets I believe. I bought an adjustable panhard bar off local CL from a guy at...
Forum: S197 Handling Section 08-14-2015, 04:20 PM
Replies: 9
Views: 268
Posted By bl817
your 2010 is a different animal all together, it...

your 2010 is a different animal all together, it has the later stylings with the 4.6 motor. in 11' Ford went to the 5.0 in the same body. "most" of the suspension parts will fit 05'-14' cars. I think...
Forum: 2005 - 2014 Mustangs 08-08-2015, 12:23 PM
Replies: 3
Views: 276
Posted By bl817
#1- any aftermarket CAI that requires a tune...

#1- any aftermarket CAI that requires a tune (JLT, Steeda, etc) will be a big improvement. JLT on local CL for 85$ with MAF, hell of a bargain if I needed a CAI.

#2- stay with stock coils, they...
Forum: 2005 - 2014 Mustangs 08-07-2015, 02:06 PM
Replies: 13
Views: 504
Posted By bl817
sounds like you need a new alternator. you may...

sounds like you need a new alternator. you may have spent a lot of money on things that weren't the problem. a failing alternator will cause all your symptoms plus some. run from the shop who said it...
Forum: 2005 - 2014 Mustangs 08-07-2015, 08:18 AM
Replies: 14
Views: 545
Posted By bl817
i see your in cali, your going to need to do...

i see your in cali, your going to need to do something about the rear 02 sensors, pretty sure you wont pass emissions out there with the cel on. you can find fairly cheap tuners (sct/bama) on CL...
Forum: 4.6L V8 Technical Discussions 08-06-2015, 09:15 PM
Replies: 36
Views: 1,844
Posted By bl817
HUH, neat

HUH, neat
Forum: 2005 - 2014 Mustangs 08-06-2015, 06:28 PM
Replies: 14
Views: 545
Posted By bl817
listen to andy and enjoy your now second baby as...

listen to andy and enjoy your now second baby as stock. the new one will keep you plenty busy and give you lots of headaches, (all good of course). no need to deal with your GT500 throwing codes and...
Forum: 4.0L V6 Technical Discussions 08-06-2015, 05:14 PM
Replies: 4
Views: 228
Posted By bl817
the cowl drains and cowl clip gaskets are...

the cowl drains and cowl clip gaskets are separate leak points. 10 cowl clip gaskets and 2 clogged cowl drains, overflows into the cabin filter.
Forum: 2005 - 2014 Mustangs 08-04-2015, 08:31 PM
Replies: 8
Views: 489
Posted By bl817
how many brenspeed tunes do you have for your...

how many brenspeed tunes do you have for your car? what ever you do, it wont pass tomorrow as youll be messing with the comp and it will throw not ready codes. changing back to the stock air box and...
Forum: 4.6L V8 Technical Discussions 08-04-2015, 07:18 PM
Replies: 36
Views: 1,844
Posted By bl817
great write up and pics. I think your gap is...

great write up and pics. I think your gap is wrong though. factory spec is .0040 to .0050 iirc. motorcraft sp514 plugs come gapped .0054 or close. those plugs you pulled out didn't look that bad at...
Showing results 1 to 25 of 216

 
Forum Jump
 
Advertising
Featured Sponsors
Vendor Directory
New Sponsors
All times are GMT -5. The time now is 11:58 AM.>

© Internet Brands, Inc.


This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company
Emails Backup