MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Search


Showing results 1 to 25 of 491
Search took 0.24 seconds.
Search: Posts Made By: Andy13186
Forum: 2005-2014 Mustangs 11-02-2015, 11:41 AM
Replies: 16
Views: 1,687
Posted By Andy13186
It would be very close and id bet youd rub with...

It would be very close and id bet youd rub with that much lowering. It also depends on the wheel offset. I wouldnt risk it though if you want to stay lowered stick with 295s (those SHOULD fit, but...
Forum: 2005-2014 Mustangs 10-19-2015, 12:29 AM
Replies: 12
Views: 644
Posted By Andy13186
Amazon.com: Hawk Performance HB453Z.585...

Amazon.com: Hawk Performance HB453Z.585 Performance Ceramic Brake Pad: Automotive

Amazon.com: Power Stop Z26-1463 Extreme Performance New Formulation Brake Pad: Automotive


How would these...
Forum: GT S197 General Discussion 10-19-2015, 12:13 AM
Replies: 10
Views: 5,089
Posted By Andy13186
Thanks. Ive had them for like 6 months and...

Thanks. Ive had them for like 6 months and usually open and close them multiple times every drive, no issues at all so far. I have the remote control setup. They are qtp low profiles.
Forum: 2005-2014 Mustangs 10-18-2015, 12:16 PM
Replies: 12
Views: 644
Posted By Andy13186
I do have basic pads. What pad would you...

I do have basic pads. What pad would you recommend for mainly normal street driving? I would prefer very low dust if possible. I may try this and hope it is somehow the pads or the springs you are...
Forum: 2005-2014 Mustangs 10-17-2015, 07:42 PM
Replies: 12
Views: 644
Posted By Andy13186
I have braked at like 130 a few times pretty hard...

I have braked at like 130 a few times pretty hard and some brake dust or smoke came in the cabin through vents once or twice. The calipers creak while at a stop if i apply the brakes and let off,...
Forum: 2005-2014 Mustangs 10-15-2015, 11:51 AM
Replies: 12
Views: 644
Posted By Andy13186
Aftermarket calipers for non-brembo rotors?

Are there any aftermarket calipers for non brembo size rotors? 13.22 inch is the size i believe. Brembos might be 14.

I got aftermarket rotors and caliper slide pins for the calipers to try to...
Forum: GT S197 General Discussion 10-14-2015, 03:54 PM
Replies: 10
Views: 5,089
Posted By Andy13186
I think some of my exhaust gas still goes through...

I think some of my exhaust gas still goes through the mufflers so its not as loud as just removing your mufflers. Its barely louder than roush exhaust, if louder at all with my setup.

2011...
Forum: 5.0L V8 Technical Discussions 10-02-2015, 06:00 PM
Replies: 17
Views: 1,029
Posted By Andy13186
possibly crank position sensor? mine misfired a...

possibly crank position sensor? mine misfired a bit a few years ago and that ended up being the problem.

does it happen only after driving for a while?
Forum: 5.0L V8 Technical Discussions 09-19-2015, 05:33 PM
Replies: 35
Views: 7,474
Posted By Andy13186
I agree with p51, revving higher accomplishes the...

I agree with p51, revving higher accomplishes the same thing as building boost at the line, your engine will be making more power at higher rpm even without boost, enough power to spin the tires, so...
Forum: 2005-2014 Mustangs 09-17-2015, 02:59 PM
Replies: 8
Views: 649
Posted By Andy13186
Still broken and they are saying monday at...

Still broken and they are saying monday at earliest, and i have to pay rental... Day 97.

Edit * I got it back in working condition on day 98
Forum: GT S197 General Discussion 09-17-2015, 01:14 PM
Replies: 10
Views: 5,089
Posted By Andy13186
I have cutouts on my 5.0 and I like them. I put...

I have cutouts on my 5.0 and I like them. I put them near the back end of the car behind the resonators infront of the rear axle with them aimed outward. Its nice to be able to open them and close...
Forum: 2005-2014 Mustangs 09-12-2015, 12:54 PM
Replies: 8
Views: 649
Posted By Andy13186
Thanks guys. Heres some of the story ...

Thanks guys. Heres some of the story


6/12/15 I dropped my car off at my local Ford dealer and where I get my car serviced after the car will not shift into 2nd gear any more. I get a rental...
Forum: 2005-2014 Mustangs 09-09-2015, 03:49 PM
Replies: 8
Views: 649
Posted By Andy13186
Forum: 5.0L V8 Technical Discussions 09-03-2015, 03:09 PM
Replies: 35
Views: 7,474
Posted By Andy13186
I think the paxton would be easier on the...

I think the paxton would be easier on the drivetrain for a manual car. Roush would probably blow out your transmission if you had good tires on. Upgrading transmission to a t56 magnum requires...
Forum: 2005-2014 Mustangs 08-05-2015, 04:06 PM
Replies: 14
Views: 906
Posted By Andy13186
If its a daily non-track car just keep the cats, ...

If its a daily non-track car just keep the cats, the sound isnt good without imo, and it smells bad and is bad for the environment.

put that money into your childrens college 529 plan or...
Forum: 2005-2014 Mustangs 06-20-2015, 10:27 PM
Replies: 16
Views: 1,208
Posted By Andy13186
I am pretty upset about how long of a backorder...

I am pretty upset about how long of a backorder it is.

Also, I just visited my car thats been in the shop for 11 days, and I found that it was sitting out in the rain with the hood unlatched,...
Forum: 2005-2014 Mustangs 06-18-2015, 10:29 PM
Replies: 16
Views: 1,208
Posted By Andy13186
Well the installation of the parts is the big...

Well the installation of the parts is the big thing, the ford service technicians probably have to prioritize airbags over everything, and they have to learn how to do the installation on many ford...
Forum: 2005-2014 Mustangs 06-18-2015, 09:55 PM
Replies: 16
Views: 1,208
Posted By Andy13186
Lol i had a 4 door 2015 silverado rental, but it...

Lol i had a 4 door 2015 silverado rental, but it was so hard to park at night in my carport so i returned it and got a focus.
Forum: 2005-2014 Mustangs 06-18-2015, 09:53 PM
Replies: 16
Views: 1,208
Posted By Andy13186
My mustang is in the shop with a broken 2nd and...

My mustang is in the shop with a broken 2nd and 4th gear synchro, it has been in since the 9th. All i have heard is that its backordered until most likely the end of next month. I have a rental...
Forum: S197 Handling Section 06-06-2015, 08:26 PM
Replies: 15
Views: 1,172
Posted By Andy13186
you would have to have the stock springs on the...

you would have to have the stock springs on the rear to not rub the fenders hard, most likely
Forum: 2005-2014 Mustangs 05-28-2015, 06:11 PM
Replies: 11
Views: 762
Posted By Andy13186
Roush axlebacks are basically perfect, if you...

Roush axlebacks are basically perfect, if you keep the rest of your exhuast stock which i recommend.
Forum: 2005-2014 Mustangs 05-24-2015, 11:52 AM
Replies: 13
Views: 1,132
Posted By Andy13186
You could put stock mufflers back on, and get...

You could put stock mufflers back on, and get electric cutouts that you can open whenever you want it to be loud. Thats what i have and its great.
Forum: S197 Handling Section 04-17-2015, 11:50 AM
Replies: 10
Views: 888
Posted By Andy13186
What size and brand of tires and how old are...

What size and brand of tires and how old are they? My coworkers tire disintegrated randomly, i think it was a dunlop and it lost like large amounts of tread. This tire looks like it rubbed the...
Forum: 2005-2014 Mustangs 04-01-2015, 07:22 PM
Replies: 10
Views: 1,009
Posted By Andy13186
possibly, it also depends on the offset and size...

possibly, it also depends on the offset and size of the rim though.
Forum: 2005-2014 Mustangs 03-31-2015, 10:10 PM
Replies: 10
Views: 1,009
Posted By Andy13186
315 35 20 rubs bad with lowering springs, 305 35...

315 35 20 rubs bad with lowering springs, 305 35 20 didnt rub with steeda sports 1.25 lower in the rear.

315 35 20 is barely ok with stock springs.
Showing results 1 to 25 of 491

 
Forum Jump
 

All times are GMT -5. The time now is 01:32 PM.



This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company