MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Search


Showing results 1 to 25 of 500
Search took 0.13 seconds.
Search: Posts Made By: Z28KLR
Forum: 4.6L (1996-2004 Modular) Mustang Yesterday, 12:16 PM
Replies: 8
Views: 168
Posted By Z28KLR
Yup. I used a thread from SVTP (link below) as my...

Yup. I used a thread from SVTP (link below) as my "guide" for the most part, but basically you just retain your existing brackets, take a few measurements and drill holes into the seatpans of the...
Forum: 4.6L General Discussion Yesterday, 10:14 AM
Replies: 6
Views: 123
Posted By Z28KLR
Are you looking for an entire set or just...

Are you looking for an entire set or just replacing that one with the lug nut issue that from your other thread sounds like it might have gotten chewed up a little when you lost the tire?

If just...
Forum: 4.6L (1996-2004 Modular) Mustang 07-24-2016, 11:41 AM
Replies: 6
Views: 125
Posted By Z28KLR
But with the PCV disconnected, there is a light...

But with the PCV disconnected, there is a light amount of vacuum from the oil fill cap (as there generally should be)?

Is there vacuum from the PCV line, or pressure? Correct answer is that there...
Forum: 4.6L General Discussion 07-24-2016, 11:26 AM
Replies: 14
Views: 266
Posted By Z28KLR
FWIW, replacing the hub/bearing assembly is super...

FWIW, replacing the hub/bearing assembly is super easy. Pretty sure it's gotta come off anyway to deal with the stud, and at that point it may be easier to just replace the entire thing. Did one on...
Forum: 4.6L General Discussion 07-23-2016, 02:34 PM
Replies: 14
Views: 266
Posted By Z28KLR
Mine weren't broken like that but I did lose the...

Mine weren't broken like that but I did lose the key. I used a (I think) 21mm 1/2" drive deep socket and pounded it on the lock nuts with a bfh and then broke them loose with a 18" x 1/2" drive bar....
Forum: 4.6L (1996-2004 Modular) Mustang 07-23-2016, 02:23 PM
Replies: 8
Views: 168
Posted By Z28KLR
My driver seat had gotten to the point that it...

My driver seat had gotten to the point that it looked as if terrorists had flown a plane into it. I considered various options - TMI kit (very pricy, plus probably pro installation), used 99-04 Cobra...
Forum: 4.6L (1996-2004 Modular) Mustang 07-23-2016, 02:03 PM
Replies: 4
Views: 111
Posted By Z28KLR
Yeah, so just turn the switch to the On/Run...

Yeah, so just turn the switch to the On/Run position. And then back to Off when prompted. Do not try to crank the engine.
Forum: General Tech 07-23-2016, 01:59 PM
Replies: 2
Views: 133
Posted By Z28KLR
Not sure where you are in CA but keep your eyes...

Not sure where you are in CA but keep your eyes out on CL. Been seeing a couple different sets on Inland Empire/Orange County/Los Angeles pages, not sure if they are what you want or not but there...
Forum: 4.6L (1996-2004 Modular) Mustang 07-22-2016, 12:26 PM
Replies: 8
Views: 168
Posted By Z28KLR
$5-7K is probably your range. Since specific...

$5-7K is probably your range. Since specific values vary regionally, I would check on KBB and any other car value references for what they say, and then go on Autotrader and see what other cars in...
Forum: 4.6L (1996-2004 Modular) Mustang 07-22-2016, 12:20 PM
Replies: 4
Views: 111
Posted By Z28KLR
It shouldn't ask you to crank the engine. The...

It shouldn't ask you to crank the engine. The general instruction is to turn the key to the On/Run position for 2-3 seconds and then return to Off as the device prompts.

If you are unsure of...
Forum: 4.6L (1996-2004 Modular) Mustang 07-21-2016, 04:19 PM
Replies: 12
Views: 260
Posted By Z28KLR
SuperChip? Please, no.

SuperChip? Please, no.
Forum: 4.6L (1996-2004 Modular) Mustang 07-21-2016, 12:32 PM
Replies: 3
Views: 119
Posted By Z28KLR
Common issue, mine cracked in a couple places...

Common issue, mine cracked in a couple places years ago when I installed a STB. Has gotten worse lately and will be replacing soon with a genuine Ford unit ($200). There are cheaper options, AM has a...
Forum: General Tech 07-19-2016, 01:43 PM
Replies: 1
Views: 138
Posted By Z28KLR
Spend a little extra and get a handheld device....

Spend a little extra and get a handheld device. Much more useful and easier to update/change tunes as your car grows.

It won't transform your car into a Ferarri, but yes there are very noticeable...
Forum: General Tech 07-19-2016, 01:41 PM
Replies: 3
Views: 141
Posted By Z28KLR
It is a bit slow here, but unless you have a...

It is a bit slow here, but unless you have a "classic" or S500 Mustang then it's pretty slow at most others as well. As stated above, your best bet is to post issues in a model specific subforum....
Forum: 4.6L (1996-2004 Modular) Mustang 07-16-2016, 07:35 PM
Replies: 2
Views: 136
Posted By Z28KLR
Your best bet for stock springs would be to pull...

Your best bet for stock springs would be to pull some off of a wrecked or otherwise out of commission vehicle. Check your local Craigslist page for cars being parted out in your area. Also check...
Forum: 4.6L General Discussion 07-15-2016, 12:21 PM
Replies: 14
Views: 439
Posted By Z28KLR
Thanks Soldier!

Thanks Soldier!
Forum: 4.6L (1996-2004 Modular) Mustang 07-12-2016, 07:44 PM
Replies: 1
Views: 112
Posted By Z28KLR
Generally this is indicative of a bad head...

Generally this is indicative of a bad head gasket; compression escaping the combustion chamber and into a coolant passage. You probably just spent a sh!t ton of money on an engine rebuild though, so...
Forum: 4.6L (1996-2004 Modular) Mustang 07-10-2016, 10:19 PM
Replies: 11
Views: 446
Posted By Z28KLR
I've done a fair amount of homework on swapping a...

I've done a fair amount of homework on swapping a V8 into a 6 cylinder classic (see the other car listed in my sig). It's pretty far from simple or inexpensive.

You need different springs,...
Forum: 4.6L (1996-2004 Modular) Mustang 07-09-2016, 01:39 PM
Replies: 11
Views: 446
Posted By Z28KLR
Both sound like ok cars, and yeah worse case...

Both sound like ok cars, and yeah worse case scenario on the '00 you could find a gently used engine out of a CrownVic or Towncar to swap in. I would lean toward the '00 due to the lower mileage and...
Forum: 4.6L General Discussion 07-09-2016, 01:27 PM
Replies: 8
Views: 221
Posted By Z28KLR
The black stuff on your car - hood scoop, gas...

The black stuff on your car - hood scoop, gas door and wheels; it's not my thing but I get why others like it. Having a few contrasting things like you do I think looks ok but just be careful because...
Forum: 4.6L General Discussion 07-08-2016, 10:30 PM
Replies: 8
Views: 221
Posted By Z28KLR
Go to car shows, check out other people's cars...

Go to car shows, check out other people's cars there or on the road or in magazines or on the interweb. See what you like.

I could tell you what to do but then you'd just end up with my car. The...
Forum: 4.6L (1996-2004 Modular) Mustang 07-08-2016, 10:19 PM
Replies: 7
Views: 286
Posted By Z28KLR
They don't do a whole lot. Little bit of midrange...

They don't do a whole lot. Little bit of midrange gains, little bit better throttle response, little extra noise. Don't believe any of the advertising hype. Pick one based on looks and budget - as a...
Forum: 4.6L (1996-2004 Modular) Mustang 07-07-2016, 10:52 PM
Replies: 2
Views: 192
Posted By Z28KLR
The term "modular" actually came about to...

The term "modular" actually came about to describe the assembly line that 4.6 and 5.4 in their various configurations were assembled on, and how they could quickly switch between the tooling on the...
Forum: 4.6L General Discussion 07-07-2016, 07:59 PM
Replies: 14
Views: 439
Posted By Z28KLR
Thanks dude. It still needs some 270's and a P1SC...

Thanks dude. It still needs some 270's and a P1SC but she still looks pretty decent for being a 15 year old car.
Forum: 4.6L General Discussion 07-07-2016, 02:01 AM
Replies: 14
Views: 439
Posted By Z28KLR
One more...

One more...
Showing results 1 to 25 of 500

 
Forum Jump
 

All times are GMT -5. The time now is 03:30 AM.



This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company