MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Search


Showing results 1 to 25 of 90
Search took 0.04 seconds.
Search: Posts Made By: corker
Forum: V6 (1994-2004) Mustangs 06-28-2016, 07:02 AM
Replies: 2
Views: 242
Posted By corker
Those are O2 heater circuit codes. You said you...

Those are O2 heater circuit codes. You said you have 12v at both sensors - next check for 12v at sensor with the sensors connected & check the resistance readings of sensor heaters with wiring...
Forum: V6 (1994-2004) Mustangs 05-19-2016, 12:10 PM
Replies: 5
Views: 261
Posted By corker
A/C circuit Wiring Diagram Attached ...

A/C circuit Wiring Diagram Attached

http://cimg3.ibsrv.net/gimg/mustangforums.com-vbulletin/1540x2000/80-mustang_a_c_ea6626d1414ec0973bfbb8f751722294d802bdb5.jpg
2000 V6 Mustang Manual A/C
Forum: V6 (1994-2004) Mustangs 05-19-2016, 08:46 AM
Replies: 5
Views: 261
Posted By corker
OK, if you turn on your A/C and the compressor...

OK, if you turn on your A/C and the compressor comes on but your fan doesn't, then it has nothing to do with a thermostat - you got a fan or fan circuit problem.
Check:
- 30 Amp fan fuse
- Check...
Forum: V6 (1994-2004) Mustangs 03-21-2016, 09:58 AM
Replies: 16
Views: 572
Posted By corker
I guess you're not getting any codes? Start...

I guess you're not getting any codes?

Start ruling things out:
Hook up a fuel pressure gauge and monitor fuel pressure as it's dying - FP should be steady and not change.
Check the engine for...
Forum: V6 (1994-2004) Mustangs 03-02-2016, 08:11 AM
Replies: 1
Views: 222
Posted By corker
I would start by isolating the cylinder that may...

I would start by isolating the cylinder that may be misfiring. With the engine off, loosen all the plug wires at the coil pack one-by-one - pull each wire out and put it back in (makes it easier to...
Forum: V6 (1994-2004) Mustangs 02-17-2016, 01:10 PM
Replies: 2
Views: 205
Posted By corker
I just had the same code on my 2000 V6. It...

I just had the same code on my 2000 V6. It turned out to be the DPFE sensor (pressure sensor). Check the hose coming into it from the passenger side exhaust manifold - that hose gets hot as the...
Forum: V6 (1994-2004) Mustangs 01-15-2016, 06:39 AM
Replies: 5
Views: 304
Posted By corker
TO bearing is a little easier to diagnose - at...

TO bearing is a little easier to diagnose - at idle, with clutch disengaged, open door and listen for any noise. Then, step on clutch pedal (pressure on TO bearing) and listen for any change in noise...
Forum: V6 (1994-2004) Mustangs 01-14-2016, 03:34 PM
Replies: 5
Views: 304
Posted By corker
First check for gear oil. Is the whine all the...

First check for gear oil. Is the whine all the time, louder on acceleration, louder when coasting? Pay close attention to the sound the next time you drive - does it change on turns, only straight...
Forum: V6 (1994-2004) Mustangs 01-14-2016, 03:27 PM
Replies: 14
Views: 498
Posted By corker
I take it you you are not getting any codes - CEL...

I take it you you are not getting any codes - CEL not on? Is your dash temp gauge reading normal?
Below are the specs to check the readings at your Engine Coolant Temp Sensor & your Intake Air...
Forum: V6 (1994-2004) Mustangs 01-13-2016, 09:06 AM
Replies: 4
Views: 323
Posted By corker
A dirty throttle body will cause the IAC to act a...

A dirty throttle body will cause the IAC to act a little weird - fluctuate at times and cause stalling. Also, check for vac leaks - get an old windex spray bottle and fill with water - spray all vac...
Forum: V6 (1994-2004) Mustangs 01-13-2016, 08:48 AM
Replies: 3
Views: 459
Posted By corker
I agree with Chromeshadow on the troubleshooting....

I agree with Chromeshadow on the troubleshooting. Also 3 TO bearings in that short of a time period is highly unusual. Check clutch cable adjustment - google this topic so you understand how the...
Forum: V6 (1994-2004) Mustangs 12-14-2015, 08:34 AM
Replies: 7
Views: 336
Posted By corker
The price does seem high. I paid $3k for a 2000...

The price does seem high. I paid $3k for a 2000 base Mustang 5 years ago with 90,000 miles. If this car has a V6, check the harmonic balancer for cracks in the rubber insulator (gotta look real...
Forum: V6 (1994-2004) Mustangs 11-18-2015, 08:22 AM
Replies: 3
Views: 342
Posted By corker
OK, kind of tough to sort through your post, but...

OK, kind of tough to sort through your post, but I'll try.
1) you shouldn't have black crap coming out of fuel filter - did you check inside the tank when you had it down?
2) "Fuel pump looked...
Forum: V6 (1994-2004) Mustangs 10-29-2015, 12:37 PM
Replies: 9
Views: 684
Posted By corker
Start with an AllData or Mitchell subscription...

Start with an AllData or Mitchell subscription and print off the wiring diagrams. You will have to trace out the wiring and figure this out component by component. We can help answer specific...
Forum: V6 (1994-2004) Mustangs 10-29-2015, 12:29 PM
Replies: 4
Views: 395
Posted By corker
Delphi pump is available for a '98 V6 at...

Delphi pump is available for a '98 V6 at Rockauto.com for $55 + shipping. If you are running a stock fuel system, there is no need for a specialty high output pump. I wouldn't basterdize the fuel...
Forum: V6 (1994-2004) Mustangs 10-19-2015, 08:50 AM
Replies: 2
Views: 530
Posted By corker
Here's what the service manual says. 41616

Here's what the service manual says.

41616
Forum: V6 (1994-2004) Mustangs 09-25-2015, 06:58 AM
Replies: 4
Views: 964
Posted By corker
I have found almost everything I need at a...

I have found almost everything I need at a U-Pick-It boneyard. There are plenty of V-6 mustangs there with most of the parts intact. The bumpers, grills and interior parts are usually picked clean....
Forum: V6 (1994-2004) Mustangs 09-25-2015, 06:51 AM
Replies: 8
Views: 412
Posted By corker
Here's a CC wiring diagram for a 2000 V6 ...

Here's a CC wiring diagram for a 2000 V6

http://cimg2.ibsrv.net/gimg/mustangforums.com-vbulletin/1540x2000/80-mustang_cruise_804cb0aac0298230b9c2bd3d8729089d2ec757f6.jpg
Forum: V6 (1994-2004) Mustangs 09-24-2015, 06:52 AM
Replies: 8
Views: 412
Posted By corker
Got cruise on my 2000 5spd as well. Doesn't...

Got cruise on my 2000 5spd as well. Doesn't matter if it is an Auto or Manual, cruise works with both.
Forum: V6 (1994-2004) Mustangs 09-22-2015, 08:31 AM
Replies: 2
Views: 786
Posted By corker
You can purchase the kit as jwog666 says above,...

You can purchase the kit as jwog666 says above, or if you want to figure it out I've included a radio circuit diagram from a 2000. It is a busy diagram, so I'm not sure how its going to come out. ...
Forum: V6 (1994-2004) Mustangs 09-16-2015, 07:11 AM
Replies: 1
Views: 2,170
Posted By corker
I have fixed a few mustangs with this same...

I have fixed a few mustangs with this same problem. 2 were worn out FP's and 1 was a corroded ground wire that would make better contact as the engine cranked. I will do voltage and ground tests...
Forum: V6 (1994-2004) Mustangs 09-16-2015, 06:58 AM
Replies: 2
Views: 665
Posted By corker
For the trans, sounds like a synchro failure. ...

For the trans, sounds like a synchro failure. Take the time to watch the youtube video in the link below and you will understand what is happening inside your trans (also could be a clutch release...
Forum: V6 (1994-2004) Mustangs 08-27-2015, 07:13 AM
Replies: 23
Views: 2,321
Posted By corker
Also, after a few "fender benders" I utilized a...

Also, after a few "fender benders" I utilized a local U-pick-it parts yard to get replacement body parts - the yard was full of mustangs. I picked up the paint at the site below and learned how to...
Forum: V6 (1994-2004) Mustangs 08-26-2015, 07:14 AM
Replies: 23
Views: 2,321
Posted By corker
That's great that he wants a mustang. I did the...

That's great that he wants a mustang. I did the same - had a '68 many moons ago and my son bought a 1-owner 2000 base model with a V-6 5 years ago. The key is 1-owner; the majority of 1-owner cars...
Forum: V6 (1994-2004) Mustangs 08-21-2015, 08:12 AM
Replies: 11
Views: 1,492
Posted By corker
I looked all thru my Mitchell subscription and...

I looked all thru my Mitchell subscription and there isn't a single diagram of the MAF or how is mounted. My son has the car now, so I can't check it out and I don't recall when I had it out to...
Showing results 1 to 25 of 90

 
Forum Jump
 

All times are GMT -5. The time now is 12:26 PM.



This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company