MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Search


Showing results 1 to 25 of 325
Search took 0.19 seconds.
Search: Posts Made By: MADSCOTSMAN
Forum: GT S197 General Discussion 05-13-2016, 07:30 AM
Replies: 1
Views: 193
Posted By MADSCOTSMAN
FWIW, I read on another forum that the part...

FWIW, I read on another forum that the part number for the plastic retaining clip replacement is AR3Z-7A581-A ???? Couldn't find an image for it anywhere but is only like $3, might be worth a try...
Forum: 2005-2014 Mustangs 04-05-2016, 06:01 AM
Replies: 4
Views: 309
Posted By MADSCOTSMAN
Typically in these cars a rapid flashing interior...

Typically in these cars a rapid flashing interior indicator is the cars way of telling you a bulb is out. It's called Hyperflashing. When you change an incandescent bulb to an LED, the car thinks...
Forum: 2005-2014 Mustangs 03-29-2016, 06:27 AM
Replies: 10
Views: 771
Posted By MADSCOTSMAN
If you are looking for a mount for your Garmin, I...

If you are looking for a mount for your Garmin, I would recommend this one:
Amazon.com: Arkon GPS Car Mount for Garmin nuvi 50 200 2013 24x5 25x5 Series GPS Lighter Socket Mount with Mini USB...
Forum: 2005-2014 Mustangs 03-18-2016, 05:50 AM
Replies: 3
Views: 282
Posted By MADSCOTSMAN
Step #2 C. Make sure these 2 are tight? ...

Step #2 C. Make sure these 2 are tight?


Step #2 F. Apply grease?


Step #2 G. Re-Tighten these 4?

The Barton shifter comes now with a gasket that sits underneath the shifter. Does...
Forum: 2005-2014 Mustangs 03-16-2016, 05:14 AM
Replies: 12
Views: 637
Posted By MADSCOTSMAN
If you put that OEM part number in ebay, you can...

If you put that OEM part number in ebay, you can find them $30-$50 cheaper...
Forum: 2010-current S197 Appearance Section 02-24-2016, 05:18 AM
Replies: 9
Views: 976
Posted By MADSCOTSMAN
Looks good.. Would have been even better IMO if...

Looks good.. Would have been even better IMO if you could have brought the inside of the 5 and the 0 up to the surface as well. Then there would be no more cursing as you try to dig the dirt/dust...
Forum: 2005-2014 Mustangs 01-11-2016, 09:31 AM
Replies: 9
Views: 523
Posted By MADSCOTSMAN
The 07-09 gt500kr strut bar should fit. ...

The 07-09 gt500kr strut bar should fit.
http://www.americanmuscle.com/ford-strut-brace-0709gt500.html
I have it on my 12' RS3...
Forum: Parts For Sale 11-27-2015, 11:24 AM
Replies: 1
Views: 655
Posted By MADSCOTSMAN
Roush rear side splitters

Had these on my 13' and took them off when I traded it in on my 12' RS3 thinking I could install them on that car since it doesn't have the rear splitters from ROUSH. Turns out they won't fit on the...
Forum: 2005-2014 Mustangs 10-27-2015, 05:59 AM
Replies: 6
Views: 345
Posted By MADSCOTSMAN
Sealing the hood won't help as it is not related...

Sealing the hood won't help as it is not related to water, the issue is actually caused by an iron contaminant on the aluminum hood at ford prior to the hoods being painted which leads to galvanic...
Forum: 2010-current S197 Appearance Section 10-08-2015, 09:18 AM
Replies: 4
Views: 9,121
Posted By MADSCOTSMAN
Pretty sure you cannot get a ticket in another...

Pretty sure you cannot get a ticket in another state for having window tint on your car that is legal in the state in which the car is registered.... So cross country trips shouldn't be an issue. I...
Forum: Saleen, Roush and Boss Mustangs 09-30-2015, 01:41 PM
Replies: 5
Views: 850
Posted By MADSCOTSMAN
The issue was my hood having a slight bend in it....

The issue was my hood having a slight bend in it. Had my mechanic drop the hood liner and cut some of the under-webbing from the hood, but not enough to affect it structurally. End result is a...
Forum: Saleen, Roush and Boss Mustangs 09-30-2015, 10:41 AM
Replies: 2
Views: 708
Posted By MADSCOTSMAN
$1200 for VMP kit. Comes with SCT tuner (you can...

$1200 for VMP kit. Comes with SCT tuner (you can opt out of the tuner if you already have one and save some $$$), VMP tune, JLT Cold Air Intake, 82mm Super Charger Pulley, 90mm Idler Pulley (Both...
Forum: Parts For Sale 09-30-2015, 10:33 AM
Replies: 11
Views: 1,127
Posted By MADSCOTSMAN
Yup, still have them and the AIRAID spacer.

Yup, still have them and the AIRAID spacer.
Forum: 2010-current S197 Appearance Section 09-01-2015, 05:30 PM
Replies: 5
Views: 1,012
Posted By MADSCOTSMAN
I bought the ROUSH black anodized ones for my...

I bought the ROUSH black anodized ones for my 2012 RS3. I have the GT500 KR (Ford Racing) STB on my car and was able to get the smaller hex bolt covers on, even on the inside screws where the STB...
Forum: 2005-2014 Mustangs 08-24-2015, 05:37 AM
Replies: 19
Views: 2,013
Posted By MADSCOTSMAN
Check the Hood (underside and front edge), and...

Check the Hood (underside and front edge), and the trunk for the dreadful corrosion that is common on all 05-14's. If it is near the top surface of either, it is only a matter of time before it...
Forum: Off Topic 08-13-2015, 09:05 AM
Replies: 18
Views: 677
Posted By MADSCOTSMAN
If you don't have a schit eatin' dog, a teaspoon...

If you don't have a schit eatin' dog, a teaspoon of conveniently spread peanut butter makes for a quick conversion :D:D:D
Forum: 2010-current S197 Appearance Section 08-05-2015, 07:04 AM
Replies: 13
Views: 1,093
Posted By MADSCOTSMAN
I just took my 12's dash apart to run power to my...

I just took my 12's dash apart to run power to my GPS. For the center vents, there is one screw on the left and two on the right holding it in, behind each of the side dashboard pieces. The left...
Forum: 2005-2014 Mustangs 08-01-2015, 09:49 PM
Replies: 24
Views: 12,210
Posted By MADSCOTSMAN
OP has a 2010, the tilting headrests didn't come...

OP has a 2010, the tilting headrests didn't come until 2013...
Forum: 2005-2014 Mustangs 08-01-2015, 09:45 PM
Replies: 9
Views: 741
Posted By MADSCOTSMAN
Put away your pitchforks, torches and shovels...

Put away your pitchforks, torches and shovels :icon_viking:.... I had one on my 2013 GT for a little while. I already had BAMA tunes and an AIRAID CAI on the car at the time so I didn't notice any...
Forum: Saleen, Roush and Boss Mustangs 07-22-2015, 11:52 AM
Replies: 2
Views: 708
Posted By MADSCOTSMAN
VMP Phase III package for Roush RS3

Just thought I'd give some major props to Justin and the rest of VMP on here. :icon_clapclap::icon_headbang::icon_worthy:


I was fortunate enough to purchase a 2012 Roush RS3 with only 1200...
Forum: Saleen, Roush and Boss Mustangs 07-22-2015, 07:32 AM
Replies: 5
Views: 850
Posted By MADSCOTSMAN
Roush TVS w/ Strut Tower Brace??

I bought one of the Ford Racing 07-09 GT500 Strut Tower Braces and installed it on my 2012 RS3 after reading online and on AM's customer reviews that it would clear the JLT intake, the TVS blower,...
Forum: 2005-2014 Mustangs 07-18-2015, 11:54 PM
Replies: 47
Views: 3,329
Posted By MADSCOTSMAN
LOLOL Yeah, they'll probably call you and...

LOLOL


Yeah, they'll probably call you and ask you to pull fuse #33 every month or so to allow their recordings to start working again.
Forum: 2010-current S197 Appearance Section 07-10-2015, 10:47 AM
Replies: 13
Views: 1,029
Posted By MADSCOTSMAN
Be prepared to spend hours removing the residue...

Be prepared to spend hours removing the residue from the 3M double sided tape, and for blisters on your fingertips. Even trying heat, automotive Goo gone (the Citrus kind as the other one will...
Forum: 2005-2014 Mustangs 06-23-2015, 05:42 AM
Replies: 23
Views: 1,769
Posted By MADSCOTSMAN
I love both GHIG and GB. Not a big fan of the...

I love both GHIG and GB. Not a big fan of the wide black stripes on GHIG, especially the ones on the side (It's obvious it's a GT with the 5.0 emblems on the fenders, why restate it, but that's...
Forum: Parts For Sale 06-22-2015, 05:50 PM
Replies: 11
Views: 1,127
Posted By MADSCOTSMAN
Never received an email. Got the Sound tube...

Never received an email. Got the Sound tube delete cap and clamp from AIRAID yesterday. Installed and ready to go. Also have the ROUSH rear splitters from my 13' left over if anyone wants to make...
Showing results 1 to 25 of 325

 
Forum Jump
 

All times are GMT -5. The time now is 06:19 AM.



This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company