MustangForums.com - Search Results

Go Back   MustangForums.com > Search Forums
Search


Showing results 1 to 25 of 495
Search took 0.20 seconds.
Search: Posts Made By: DRAGUL
Forum: GT S197 General Discussion 08-21-2016, 07:48 PM
Replies: 6
Views: 223
Posted By DRAGUL
Get them powder coated.

Get them powder coated.
Forum: GT S197 General Discussion 08-18-2016, 08:33 PM
Replies: 5
Views: 229
Posted By DRAGUL
You will always get more selling it outright, if...

You will always get more selling it outright, if you can deal with the b/s that goes with it. Dealers will always low ball to make a good profit on the resale. You could check around for cars like...
Forum: 4.6L (1996-2004 Modular) Mustang 08-13-2016, 08:21 PM
Replies: 7
Views: 158
Posted By DRAGUL
Are you sure you had a good connection when you...

Are you sure you had a good connection when you pulled a vacuum? If not you would just pull a vacuum on your gauges. With a good vacuum it would pull in most of the charge without the system running.
Forum: 4.6L (1996-2004 Modular) Mustang 08-05-2016, 08:40 PM
Replies: 6
Views: 211
Posted By DRAGUL
A bad head gasket that is allowing a small leak...

A bad head gasket that is allowing a small leak of antifreeze into the cylinders can cause a misfire. Will also cause a hard start problem when cold.
Forum: New Member Area 07-31-2016, 09:23 AM
Replies: 7
Views: 201
Posted By DRAGUL
Welcome

Welcome
Forum: Wheels & Tires 07-30-2016, 08:22 PM
Replies: 9
Views: 247
Posted By DRAGUL
If you cut the tire by curbing it, there may be...

If you cut the tire by curbing it, there may be damage you don't see. It sucks but do you want to risk damaging your car if it fails.
Forum: New Member Area 07-19-2016, 07:53 PM
Replies: 8
Views: 287
Posted By DRAGUL
Welcome

Welcome
Forum: 4.6L General Discussion 07-14-2016, 08:22 PM
Replies: 7
Views: 268
Posted By DRAGUL
You were lied to.

You were lied to.
Forum: New Member Area 07-10-2016, 01:13 PM
Replies: 2
Views: 109
Posted By DRAGUL
Welcome

Welcome
Forum: New Member Area 07-02-2016, 10:18 AM
Replies: 5
Views: 146
Posted By DRAGUL
Did you do the repair yourself, or have a shop do...

Did you do the repair yourself, or have a shop do it?
Forum: 4.6L (1996-2004 Modular) Mustang 06-25-2016, 11:24 PM
Replies: 25
Views: 692
Posted By DRAGUL
You never want to use compressed air on any...

You never want to use compressed air on any system. Compressed air contains moisture. Use nitrogen only.
Forum: 4.6L (1996-2004 Modular) Mustang 05-31-2016, 08:19 PM
Replies: 5
Views: 233
Posted By DRAGUL
Turn the key to on and listen for the fuel pump...

Turn the key to on and listen for the fuel pump to prime. Fuel pumps always seem to die with no warning.
Forum: New Member Area 05-20-2016, 07:37 PM
Replies: 5
Views: 148
Posted By DRAGUL
Welcome

Welcome
Forum: New Member Area 05-17-2016, 07:47 PM
Replies: 5
Views: 132
Posted By DRAGUL
Welcome

Welcome
Forum: New Member Area 05-15-2016, 08:10 AM
Replies: 11
Views: 380
Posted By DRAGUL
Welcome

Welcome
Forum: General Tech 05-14-2016, 08:50 PM
Replies: 5
Views: 201
Posted By DRAGUL
My guess would be the drivers door, as this door...

My guess would be the drivers door, as this door gets the most use.
Forum: General Tech 05-14-2016, 11:17 AM
Replies: 5
Views: 201
Posted By DRAGUL
The switch on the light controls the bulb for the...

The switch on the light controls the bulb for the map light. This bulb is not the same as the one that comes on when you open the door, that bulb is in the middle of the light. It is possible one of...
Forum: Off Topic 05-14-2016, 11:09 AM
Replies: 15
Views: 213
Posted By DRAGUL
I used a blade of grass across the grid then...

I used a blade of grass across the grid then plugged it in.
Forum: New Member Area 05-08-2016, 08:13 AM
Replies: 4
Views: 127
Posted By DRAGUL
Welcome

Welcome
Forum: SVT Forums 05-04-2016, 07:13 PM
Replies: 5
Views: 367
Posted By DRAGUL
It is easier to go the aftermarket route. There...

It is easier to go the aftermarket route. There is a ton of parts that are needed to install the Eaton. This comes up every once in awhile, so there are a bunch of old posts on this subject.
Forum: New Member Area 05-02-2016, 11:13 AM
Replies: 10
Views: 263
Posted By DRAGUL
Welcome

Welcome
Forum: 2005-2014 Mustangs 04-13-2016, 07:27 PM
Replies: 8
Views: 473
Posted By DRAGUL
I don't think you have to worry about the...

I don't think you have to worry about the electrical problem, considering it was 8 years ago.
Forum: 2005-2014 Mustangs 04-09-2016, 12:32 PM
Replies: 6
Views: 618
Posted By DRAGUL
Had mine on my 05 powder coated last year with no...

Had mine on my 05 powder coated last year with no issues. I also re-used the gaskets. I was not aware of the rubber grommet, and I have not had a problem. Not sure if the 09 covers are identical to...
Forum: General Tech 04-05-2016, 08:08 PM
Replies: 1
Views: 173
Posted By DRAGUL
What year is your car? The early S197 did not...

What year is your car? The early S197 did not have felt on the inside weather strip where it contacts the window. If yours is just the rubber, it will scratch up the tint. You would need to go with...
Forum: 4.6L (1996-2004 Modular) Mustang 03-19-2016, 02:29 PM
Replies: 1
Views: 131
Posted By DRAGUL
Need to have a Time Sert installed.

Need to have a Time Sert installed.
Showing results 1 to 25 of 495

 
Forum Jump
 

All times are GMT -5. The time now is 11:59 PM.



This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company