MustangForums.com - Search Results


Showing results 1 to 25 of 498
Search took 0.55 seconds.
Search: Posts Made By: ALMOST STOCK
Forum: 5.0L (1979-1995) Mustang 09-27-2016, 09:41 PM
Replies: 4
Views: 349
Posted By ALMOST STOCK
Are you sure it's the over flow tube and not the...

Are you sure it's the over flow tube and not the rubber seal between the fill tube and the gas tank?
Forum: 5.0L (1979-1995) Mustang 05-09-2016, 11:20 AM
Replies: 10
Views: 443
Posted By ALMOST STOCK
When you say door moulding are you talking about...

When you say door moulding are you talking about the piece at the top of the door next to the side window glass?
Forum: 5.0L (1979-1995) Mustang 05-09-2016, 10:55 AM
Replies: 10
Views: 443
Posted By ALMOST STOCK
3M Windo- Weld Ribbon Sealer Amazon.com: 3M...

3M Windo- Weld Ribbon Sealer
Amazon.com: 3M 08612 Window-Weld 3/8" x 15' Round Ribbon Sealer Kit: Automotive
Forum: 5.0L (1979-1995) Mustang 04-15-2016, 11:39 AM
Replies: 7
Views: 344
Posted By ALMOST STOCK
I've ran the March Performance Power & Amp...

I've ran the March Performance Power & Amp underdrive pulleys for 13 years with the stock water pump and stock alternator and I've never had a cooling problem even in stop and go traffic with the...
Forum: 5.0L (1979-1995) Mustang 02-24-2016, 01:20 PM
Replies: 5
Views: 318
Posted By ALMOST STOCK
Have you check under the distributor cap for...

Have you check under the distributor cap for moisture?
Forum: 5.0L (1979-1995) Mustang 02-24-2016, 01:16 PM
Replies: 5
Views: 660
Posted By ALMOST STOCK
The fuel pump relay contacts are stuck together...

The fuel pump relay contacts are stuck together or the Tan/Lt Green wire has shorted to ground. In extreme ghetto cases, the pump relay may have been bypassed. Remove the fuel pump relay from its...
Forum: 5.0L (1979-1995) Mustang 02-14-2016, 11:55 AM
Replies: 2
Views: 421
Posted By ALMOST STOCK
You might want to give this a try first. ...

You might want to give this a try first.

http://sbftech.com/index.php/topic,29632.msg314401/topicseen.html#msg314401
Forum: 5.0L (1979-1995) Mustang 02-05-2016, 10:47 AM
Replies: 3
Views: 323
Posted By ALMOST STOCK
Once I had the tube out I use a round wire brush...

Once I had the tube out I use a round wire brush to drag thru the tube.
http://www.tptools.com/Round-Wire-Brushes,2812
If you can't get the wire through the tube then you'll to use the TB cleaner...
Forum: 5.0L (1979-1995) Mustang 02-04-2016, 11:28 AM
Replies: 5
Views: 269
Posted By ALMOST STOCK
Cheap and Easy ...

Cheap and Easy http://forums.corral.net/forums/13963633-post39.html
Forum: 5.0L (1979-1995) Mustang 02-04-2016, 11:14 AM
Replies: 3
Views: 323
Posted By ALMOST STOCK
I removed the crossover tube on my 89 without...

I removed the crossover tube on my 89 without removing anything it's a slow process but doable.
There are only 2 bolts to remove and the clap on the rubber hose at the check valve.
Once you have...
Forum: 5.0L (1979-1995) Mustang 01-19-2016, 02:19 PM
Replies: 2
Views: 257
Posted By ALMOST STOCK
I might have something for an 1989 Mustang

I might have something for an 1989 Mustang
Forum: 5.0L (1979-1995) Mustang 08-30-2015, 11:34 AM
Replies: 2
Views: 615
Posted By ALMOST STOCK
The nut should be 5/16-16 not sure what grade...

The nut should be 5/16-16 not sure what grade bolt .


OIL PUMP BOLTS there are 4 bolts
The bolts that hold the oil pump to the block are 3/8-16.
The bolts that hold the pick-up to the pump are...
Forum: 5.0L (1979-1995) Mustang 03-05-2015, 03:47 PM
Replies: 5
Views: 434
Posted By ALMOST STOCK
This will tell you everything you need to do for...

This will tell you everything you need to do for a 5 lug conversion just keep clicking on next page to view it all.


http://home.comcast.net/~mjbobbitt/mustang/page1.html
Forum: 5.0L (1979-1995) Mustang 12-31-2014, 12:41 PM
Replies: 7
Views: 1,819
Posted By ALMOST STOCK
Right beside the fuel pump relay is the wide open...

Right beside the fuel pump relay is the wide open throttle (WOT) A/C cut off relay

Curiosity you're not mixing up the Fuel pump relay cutoff that has 5 terminals with the WOT A/C cutoff that has...
Forum: General Tech 12-12-2014, 10:48 AM
Replies: 9
Views: 4,618
Posted By ALMOST STOCK
Hopefully your not referring to me when you said...

Hopefully your not referring to me when you said the guy your asking hasn't been on here in 4 yrs.
Forum: 5.0L General Discussion 12-10-2014, 12:28 PM
Replies: 88
Views: 57,477
Posted By ALMOST STOCK
Here's the link...

Here's the link http://mustangforums.com/forum/5-0l-general-discussion/351425-engine-bay-wiring-hiding-clean-up-7.html#post7590833 and at the bottom highlighted in blue will take you to the ...
Forum: 5.0L (1979-1995) Mustang 12-09-2014, 11:01 PM
Replies: 3
Views: 664
Posted By ALMOST STOCK
The bolt that holds the pulley on the tensioner...

The bolt that holds the pulley on the tensioner arm is reverse threaded.
OR
The bolt through the center of the pulley has a LH thread. Turn it clockwise to loosen it.


The bolt that holds the...
Forum: 5.0L (1979-1995) Mustang 07-06-2014, 12:22 PM
Replies: 2
Views: 571
Posted By ALMOST STOCK
Sorry no PDF file but just sent you 5 pages I...

Sorry no PDF file but just sent you 5 pages I scanned from the Mustang Shop Manual on how to adjust the quarter window glass.
Forum: 5.0L (1979-1995) Mustang 05-11-2014, 10:43 PM
Replies: 4
Views: 867
Posted By ALMOST STOCK
Valve Cover Torque Specs. 10-13 Lb-Ft

Valve Cover Torque Specs.
10-13 Lb-Ft
Forum: 5.0L (1979-1995) Mustang 05-11-2014, 04:37 PM
Replies: 6
Views: 855
Posted By ALMOST STOCK
Maybe this will help. Here is a Pic of the...

Maybe this will help.
Here is a Pic of the Diagnostic Monitor, you can see it is behind the Climate Controls.
Forum: 5.0L (1979-1995) Mustang 05-04-2014, 10:01 PM
Replies: 4
Views: 786
Posted By ALMOST STOCK
You say you don't know to get them tight try...

You say you don't know to get them tight try this.

1. Unscrew the shift knob and remove the shift boot and console cover plate assembly. (Push your fingers into the boot, hook your fingers under...
Forum: 5.0L (1979-1995) Mustang 04-27-2014, 12:37 PM
Replies: 6
Views: 629
Posted By ALMOST STOCK
Skill level I'll give it a 4 rating. If it's...

Skill level I'll give it a 4 rating.

If it's possible, determine whether the rack bushings on the car are 1-piece or two-piece by loosening the rack and trying to pull it forward enough to tell....
Forum: 5.0L (1979-1995) Mustang 04-27-2014, 10:20 AM
Replies: 2
Views: 680
Posted By ALMOST STOCK
You should have a vacuum line that is White or...

You should have a vacuum line that is White or off White in color that goes from the EGR to the rubber 4 port distributions block that is behind the passenger side strut tower. That is if someone...
Forum: 5.0L (1979-1995) Mustang 04-27-2014, 10:09 AM
Replies: 1
Views: 543
Posted By ALMOST STOCK
Sounds like someone has removed all the emissions...

Sounds like someone has removed all the emissions solenoids and just capped the vacuum lines.
The diagram below shows you where those vacuum line go, and the line that goes into the passenger side...
Forum: 5.0L (1979-1995) Mustang 04-18-2014, 06:08 PM
Replies: 8
Views: 2,912
Posted By ALMOST STOCK
You might want to check this also.

You might want to check this also.
Showing results 1 to 25 of 498

 
Forum Jump

All times are GMT -5. The time now is 01:05 PM.