Traction issues at strip!!
#12
Upr chromoly k member kit,coilover spring rate 12in 250rate,extreme bumpsteer kit for the front with strange 10 ways..17x4.5 darkstars with m&h tires..
Rear
Upr upper and lower controls arms..
Upr full length subframe connectors with seat brace
Stock gt spring with coil cut..
Lakewood 50/50 shocks..
15x10 darkstars with brand new mt 26x11.50 15 et streets..
Rear
Upr upper and lower controls arms..
Upr full length subframe connectors with seat brace
Stock gt spring with coil cut..
Lakewood 50/50 shocks..
15x10 darkstars with brand new mt 26x11.50 15 et streets..
That suspension setup should work well. The rear tires are small and the front springs are stiffer than I'd prefer, but still, unless you're making crazy power, it should hook hard.
#13
Im running the fixed length upr control arms,but have the double adjustables on the way..Maybe its in my pinion angle,but I just dont see it making that much difference..On the spring rate, I did have 12inch 175rate springs and my car would bottom out on the street..Went with the 250 spring and it fixed my ride problem..
#15
Im thinking same thing,to bad I just bought those et streets...Maybe I can sell them to a buddy or something..Only thing Im afraid of is a 28 inch tire might hurt my gear ratio,but guess its worth it for traction....I see in your sig you ran 7.4 @92..Im spinning so bad Im running 7.8 @95 mph..I have great mph so there should be no reason not to run low 7's..
#17
Best 1.89 60 ft and 7.85 1/8th mile 95.1 mph with et street 26x11.50 15..
Im averaging somewhere from 7.8's to 8.0's in 1/8th mile..My 1st gear is almost useless..
#18
Im thinking same thing,to bad I just bought those et streets...Maybe I can sell them to a buddy or something..Only thing Im afraid of is a 28 inch tire might hurt my gear ratio,but guess its worth it for traction....I see in your sig you ran 7.4 @92..Im spinning so bad Im running 7.8 @95 mph..I have great mph so there should be no reason not to run low 7's..
You should be able to run some low 7s. Just gotta figure out where the problem is. Maybe need to adjust your launch RPM/Clutch engagement, could just be a bad track/prep...really hard to say. Be cool if you could borrow some 28s before actually buying a set to see where they put you.