Lets see/hear your 2013 winter plans!!
#1
Lets see/hear your 2013 winter plans!!
With the season pretty much over for 2012...at least here in the northeast, lets see/hear your winter plans for 2013!!!!
I'll start....LOL
2003 DSG Cobra....
** MM 6 point bolt in roll bar
** Rear seat delete
** 2.93"/6# Lower ??
** JLT High Boost Intake
** 3.73's ....maybe a SRA
** Maybe a little NOS
** Front Race Seats
Working on this currently:
2004 TR Cobra....
** Complete - Just purchased TF Mach 5 Wheels, 18x9.5" ~ 18x11" Polished
I tried on my TF Mach 5 Wheels....just for fun!
I'll start....LOL
2003 DSG Cobra....
** MM 6 point bolt in roll bar
** Rear seat delete
** 2.93"/6# Lower ??
** JLT High Boost Intake
** 3.73's ....maybe a SRA
** Maybe a little NOS
** Front Race Seats
Working on this currently:
2004 TR Cobra....
** Complete - Just purchased TF Mach 5 Wheels, 18x9.5" ~ 18x11" Polished
I tried on my TF Mach 5 Wheels....just for fun!
#7
Well to start off my winter plans I'm awaiting on some wheels from someone in this thread that should be in tomorrow, so pumped!
going to wrap those in something cheap for the front, and r888's in the rear.
Have to finish off my trans project, I pulled it out a month or so ago, put in a 26 spline input, billet 3-4 dogs, mcleod tob sleeve, flywheels on it's way to mcleod for a new friction plate, and almost hav eneough saved for my promotion 750 clutch.
Also already have my NOS plate kit, going to put in 75 jets and work my way up until my stock pump/bap combo is maxed. I was planning on a 4lb lower but I might just stick with upper only for my dyno tune come spring.
Other little things i'm doing are powdercoated valve covers(already at the coaters), powered by svt coil covers, battery style intercooler tank, battery relocation, maybe little other things, we'll see.
going to wrap those in something cheap for the front, and r888's in the rear.
Have to finish off my trans project, I pulled it out a month or so ago, put in a 26 spline input, billet 3-4 dogs, mcleod tob sleeve, flywheels on it's way to mcleod for a new friction plate, and almost hav eneough saved for my promotion 750 clutch.
Also already have my NOS plate kit, going to put in 75 jets and work my way up until my stock pump/bap combo is maxed. I was planning on a 4lb lower but I might just stick with upper only for my dyno tune come spring.
Other little things i'm doing are powdercoated valve covers(already at the coaters), powered by svt coil covers, battery style intercooler tank, battery relocation, maybe little other things, we'll see.
#8
^^ Nice list!! ...I'd do a Chiseled Race Tank (or similar) in the trunk...Trust me, if you have to get to the alternator, that tank will make it a tough job!
Can't wait to see the new wheels
Can't wait to see the new wheels