FastGT

Im going to buy a bullet intake from another forum. The guy is including complete intake, cold air kit, throttle body ,cobra alternator and throttle cable bracket. I have a 2002 Mustang GT. What else will I need to put the intake on? I heard some guys say that I would have to change valve covers. Is this true? Also were can I find the parts I need if any?

__________________
2002 Mustang GT, MAC Fenderwell CAI, Steeda Underdrive Pulleys, BBK 70MM Throttle Body, Steeda Timing Adjuster, BAER 13´Front Big Barke Kit

jrherald420

the valve covers are the same

__________________

02 Mustang GT
K&N CAI,PP PLENUM,FLOW 40s,EIBACH PROs,UPR UPPER/LOWER CONTROL ARMS,STEEDA ADJ CLUTCH KIT,SPEC STAGE 1 CLUTCH+FLYWHEEL,BRIDGESTONE POTENZAS

FDNYBullitt

The valve covers for a Bullitt intakehave the oil fill on the drivers side and the coolant/heater pipe that runs under the manifold is also different. Just the first 2 I can think of.

Mikestang415

The oil cap is on the drivers side for the GT as well. The swap is easy, and yes the Cruise Control WILL WORK with a minor mod. You will notice your car will respond better at high RPM, plus the intake just looks better ! [8D]