Posts: 1328
Joined: 2/8/2007 From: St. Charles Il, and ISU Status: offline
k so im doing a auto to manual swap and i need to get the steering column out...i have already discounected the wires,, dropped the column and took out the 1 bolt holding it together in the engine compartment.....but still the thing will not budge and its pretty much the only way to get the new peddle assembly in, and the old one out.
ANy sujestions would be greatly appreciated
_____________________________
[image][/image] 4.30''s, aluminum drive shaft, tko 600, ram stage 3 clutch, upr front k member kit, E303, bbk longtubes, catless h, anderson cai, 75mm tb, lightning mass ai
Posts: 1328
Joined: 2/8/2007 From: St. Charles Il, and ISU Status: offline
ok what side did u do that on, in the engine compartmen? or under the steering wheel
_____________________________
[image][/image] 4.30''s, aluminum drive shaft, tko 600, ram stage 3 clutch, upr front k member kit, E303, bbk longtubes, catless h, anderson cai, 75mm tb, lightning mass ai
I did the same, used some good kroil to creep inbetween the two, and did the tapping with a hammer in the engine bay. The engine was out though making it alot easier.
_____________________________
95 gt. sold 88gt. sold 87 4banger. sold 91 gt. 306 h/c/i. suspension.
I used your average crow bar about 2ft long and set it against the column tube and gave it a few smack with the trusty o'l BFH. I had someone pull from the inside as well it didn't move at first untill there was some strain the same time it was being hit. I am in Canada too so with all the rust on my car it came off that way you should be able to get it. Good luck
Posts: 448
Joined: 8/12/2007 From: new york city Status: offline
spray it with some wd40 let it sit for a while then make the attempt .. i did mine with 2 people ,engine in the car .. couple of taps and someone pulling from in the car ...
_____________________________
1993 GT Hatch M/T Stock 5.0 33k Motorsport Headers,Bassani X, Mac muffs- Grant Tilt-wheel conversion Maximum Motorsports xl-full lenth subframes
Posts: 1328
Joined: 2/8/2007 From: St. Charles Il, and ISU Status: offline
haha, ya i just sat there on a stool, and pretended like i was doing rows it finaly just broke loose and came flying over
_____________________________
[image][/image] 4.30''s, aluminum drive shaft, tko 600, ram stage 3 clutch, upr front k member kit, E303, bbk longtubes, catless h, anderson cai, 75mm tb, lightning mass ai
Printable Version
dropping and pulling out steering column? - 
[/image] 4.30''s, aluminum drive shaft, tko 600, ram stage 3 clutch, upr front k member kit, E303, bbk longtubes, catless h, anderson cai, 75mm tb, lightning mass ai
RE: dropping and pulling out steering column? - 
it finaly just broke loose and came flying over
