06hoss

How do you guys like my new black out panel? It's a 3d Carbon piece and I had them paint it gloss black. I've got the Boss look going now. I just installed it today. Previously I had ordered a cheaper panel from Moss Mustang that I sent back since it was crap...don't order that one...it's just a thin piece of smoked acrylic made by GTO, but the 3D one is thick plastic that sits flush with the tail lights. I still have to wax it...making sure the tape sets up real good first.

[IMG]local://upfiles/48298/BEFCC54647FC4797B4C53ABB9437FE43.jpg[/IMG]

Riven02

I know this isnt what you are trying to show but you HAVE to adjust your driverside exhaust it is WAY off.

TPony

Looks good on red...anything else black?

aircare84

Here's mine,vinyl with Moss taillight bezels.
Also finally got around to painting & installing my chin spoiler.
aircare

[IMG]local://upfiles/47772/2DA97A5A29464DAA8B72D6A40BA3686D.jpg[/IMG]

[IMG]local://upfiles/47772/6490E07317134F9AB5D12C14059CAC04.jpg[/IMG]

06hoss

I just adjusted that driver's side muffler a few minutes ago...it was a pain in the ***! Been meaning to do that for awhile...it wasn't that bad when I installed it...it kind of settled over that way. I think one of the hangers got bent a little during shipping. I was able to pull the muffler out a little and now the tailpipe is centered better. The other side is off just a little so I went to work on it too, but it didn't really budge much...but you can barely tell on that one.

06hoss

Tpony, I haven't added anything else black, but I've trying to keep away from putting chrome over the black pieces that I do have. I like the black on red look with just a little chrome. Like, I won't get the polished foglight bezels, or tail light trim or bright grill or anything like that. The only place I put chrome on the outside was the mufflers. The engine has a lot of polished stuff on it though.


[IMG]local://upfiles/48298/750601F253DC431CBFB04FDAFCF64033.jpg[/IMG]

aircare84

06Hoss,
Who makes the chrome strut tower brace? Looks good.
I've been looking @ the Grannitelli(?) one, but blue doesn't go w/red.
aircare

[IMG]local://upfiles/47772/7AE61D7DDD8E482F84C58E1C732289B3.jpg[/IMG]

06hoss

Stange Development at http://strangedevelopment.com/home.htm. It's polished aluminum, not chromed steel. Pretty light piece. They make a brace specifically for the 07 intake cover like you have. The brace bows a little more to clear your brace. My Midwest cover was able to take a standard GT brace, but it's still higher than others. I had bought a black Steeda brace at first and had to send it back since it wouldn't fit. This company just came out with a rear shock tower brace that I just bought and installed. It's good guality stuff too, but that brace only comes as a satin finish, but it's still light weight aluminum. Real easy to install too. Here is a pic of the rear brace:

aircare84

Thank you
I'll have to look into that one as well.
Darn,it's pricy. The other one I was considering is only $75.00 with a A-frame support.

Bulitt

look at the silverhorse black out panel looks like it came off a 70 mach 1