pegsyellowtang

I have a question???
I am having new 17" black deep dish bullitt wheels put on my Mustang today. The dilemma is... my pony center caps wont' fit the new wheels.
They have a generic cap, silver with black line
Any suggestions, ideas, thoughts?? I really like my tri-bar pony caps.

Got my answer....
17X9's just barely rubbed, so we are changing to Ford OEM's (they come with pony center caps).

pegsyellowtang

Since I am a long time lurker and infrequent poster, here is my attempt at posting pictures.
I really like the look of my car with the new wheels and grille.


[IMG]local://upfiles/30737/73D2486A1532420EAB931BE2241848E5.jpg[/IMG]

[IMG]local://upfiles/30737/514F4D44FC3B46509EA5E8E1AF71ABAC.jpg[/IMG]

Sublimey

The only easy solution that we have found for this is putting the pony spinners on over the center cap. You can also see if you could maybe rig something up by going to the dealer a buying a set of the pony decals (that go on the caps) and somehow trimming them out to fit on the smaller caps- then taking the aftermarket center cap decals off and replacing them with the pony ones.

This was my problem as well. Most of the aftermarket wheels don't fit the ford center cap. When we did find one that fit...the wheels we wanted were on backorder. So we are still waiting.

Zrz11386

Hey i saw that you said u got deep dish 17x9's for your car and they rubbed, well i jus purchased 18x9's for the front and 18x10 deep dish bullitts for the rear of my car and was wonderin if i would have any problem with the fit. any suggestions for me?