V6 Plenum cover specs?
#1
V6 Plenum cover specs?
I am purchasing a Midwest Autogear V6 plenum cover to dress my underhood up some. Can someone please measure the size of the flat area in the front of it where the 4.0 emblem goes? I am having a negative of a decal made so I can paint a Pony on it. I would also like to know the length of the ribs and how much space is between the ribs and the edge. I plan to paint "POWERED BY FORD" on the sides like the GT cover has. I would really appreciate it if someone would help me out with this. Thanks.
#5
RE: V6 Plenum cover specs?
Lengthwise,mine is about 11.5 inches long (minus the front part that is curved down). From the very back, the ribs come to the front about 11inches, leaving you about 3.5 inches (I have a silver running pony there). It is about 10 inches wide, and I have about 2 inches on either side from the edges to the ribs.
Hopefully that helps....
Hopefully that helps....
#6
RE: V6 Plenum cover specs?
I'll load the specs shortly. I lost the paper I had them written on so I have to measure again which means taking off the car cover (at least partially). 11 inches for the length sounds right, but I think I remember the width being 7.5 inches.
#8
RE: V6 Plenum cover specs?
I went out and measured mine again, it is about 10 inches wide with about 2 inches on each side (ribs to edge). I thought I had it right. The 4.0 emblem is just short of 2inches tall by 5inches wide.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
0
10-01-2015 08:58 AM
Boostaddict
3.7L V6 S550 Tech 2015 - 2017
0
10-01-2015 08:57 AM