Rousch spoiler
#1
Rousch spoiler
So my Roush spoiler came in a few days ago pre-painted...I was looking over the installation plans that was sent with the piece and it says that I need a 1/2 inch rotar broach...I was wondering that since the piece size was so small if it would be possible to drill the whole with a regular 1/2 inch drill bit without negative effect?
Any and all opinions welcome...
thanks for your time
Any and all opinions welcome...
thanks for your time
#2
RE: Rousch spoiler
I just put my on this weekend,the 1/2 hole is for the centre piece,the 1/2 hole goes from the bottom of the trunk lid it is so you put the end bolt in.My advice is to read the how to do it a few times before you start drilling holes
#4
#5
RE: Rousch spoiler
[quote]ORIGINAL: charliebrown266
I just put my on this weekend,the 1/2 hole is for the centre piece,the 1/2 hole goes from the bottom of the trunk lid it is so you put the end bolt in.My advice is to read the how to do it a few times before you start drilling holes
how did you take of the sticky adhesive from under the original spoiler? Im doing it by hand now and it sucks!!!
I just put my on this weekend,the 1/2 hole is for the centre piece,the 1/2 hole goes from the bottom of the trunk lid it is so you put the end bolt in.My advice is to read the how to do it a few times before you start drilling holes
how did you take of the sticky adhesive from under the original spoiler? Im doing it by hand now and it sucks!!!
Thread
Thread Starter
Forum
Replies
Last Post
Galactic
Archive - Mustangs For Sale
10
04-29-2019 02:56 PM