3DCARBON 4PC. V6 BODY KIT , any thoughts ??
 

Any thoughts on this ?? I can get it painted for 995.00 shipped .

Bigdaddy51200

pics?

here is what the kit looks like , and this what I will get .
Parts are made of high-pressure injection molded, O.E. quality urethane. 4pc. kit includes front air dam, side skirt set and rear lower skirt available for single exhaust or dual exhaust. Available pre-painted in factory colors. 100% color match guarantee! Paint quality better than factory! Instructions and all needed hardware included.

http://img.photobucket.com/albums/v3...c/3d691034.jpg

http://img.photobucket.com/albums/v3...c/3d691566.jpg

Personally, that's my favorite cup of tea out there, but if it does catch your liking, more power to you!

"Available pre-painted in factory colors. 100% color match guarantee! Paint quality better than factory"

if the paint is better than the factory, how will that match :)

but it looks good and the price is good as well

well I need something I can install (newbie ) , don't have to change the bumpers out ,
I'm just looking to enhance my ride not do a complete transformation . I am open to any suggestions because I do have to work on budget .

here is my stang :
http://img.photobucket.com/albums/v3...mpic/photo.jpg

That's a unique looking kit, but not a big fan.

For about the same price, you could get a GT take-off front fascia and side skirts ($520) that are available in Torch Red and order a new GT/CS rear fascia (~$350) and have it painted.

I am a total newbie at this . This is why I come here :)

this is side skirts , correct ??
http://www.newtakeoff.com/Ford_musta...r_molding.aspx

GT front bumper ( If I install this then I use GT chin spoiler on it correct ??) :
http://www.newtakeoff.com/mustang-gt...2005-2008.aspx

Now I just need to GT rear bumper :)

How hard are these bumpers to install ??

I used to have this kit on my GT (minus the chin spoiler) It looks a lot better than those pictures show.

If you go with a GT bumper, the rear bumper removal on this car is a bit of a pain, but not too terrible. Remember too that a GT bumper has 2 cutouts for exhaust, and your car only has one tailpipe. You would need to deal with that.

Make sure to clean the parts and the car very very well with pure alcohol, and then you MUST use 3M adhesion promoter (on both the part AND the car). Mine came with the promoter, but if you don't get any, make sure to get some. DO NOT SKIP THAT STEP or your parts will not stay on forever.

Here is a pick of my car with that kit:

http://i173.photobucket.com/albums/w...guyton/mm3.jpg

That does look very good on yours !!! Thanks for the tip promoter.
Do you have a pic of the rear by chance ??