iDance

The catback is getting welded up in the morning. I removed the factory exhaust but trying to align ten pieces of the pypes mid-muffler kit is quite difficult on a creeper.

digitalcos

You install around it. Actually, you kinda work from the faux gas cap out.

wilkinda

I've been debating over that exact panel or the factory one. I like the emblem in the center on the factory... but the yours allows for a little customization with different emblem all together.... decisions....

staggolee

Oh ok that makes sense. I'd imagine it would be a nightmare to start from one side and try to aim it like that. Thanks for the tip

mcstang

Anyone ever see the blackout panel in Modded Mustangs that was aluminum and had ridges (kinda like louvers)? I'd love something like that because my car really doesn't have much black. The ones in the mag were custom made for an older car.

F350-6

Got a link? Any problems with rust under the magnet?

2010V6Stang

Im curious to see the 2010 CDC panel is anyone has it installed.

Tylus

I cannot recommend the magnetic one anymore

I just installed my SHR Honeycomb and when I went to pull the magnetic one off, it had started bubbling and wasn't looking very nice.


no rust though. I suggest you do either the vinyl one...or do a full cover up like I finally did

here is a before and after of it.

F350-6

Thank you. I guess I'll be ordering the vinyl.

Is there a sponsor here selling the vinyl, or should I just use the links in this thread? Might as well support the sponsors here.

So_Cali

Rocky Mountain Graphics is a sponsor here on MF. Check Them Out.