BleedinBlue

You're off-center on the hood. Look at the washer fluid sprayers in relation with the edge of the stripe.

Is that not air bubbles on the trunk, around the brake light?

jlopez07

I totally see it now lol. Ill have to pull it and re-do it. Hard to do with one person. And the trunk only has wrinkles from the dull *** blade I used to cut the light out. Too the heat gun and tried to smooth it out as much as I could. thinking of removing the light and redoing it and then just cut the vinyl and replace the light, so its smooth

jlopez07

hers some in the sun light

jlopez07

and then here was my original idea for the hood

Mustang_4life

I think that would work well. I have a black 2012, thinking of adding Grabber Blue 12" stripes. Havent pulled the trigger yet. Torn between Satin Silver or Grabber blue

jlopez07

basically was going to cover the hood and leave about a six inch gap on the middle body line. Opted against it after the heat gun stretched the vinyl to much

jlopez07

Id say just some sample pieces of the stripes and put them on and see which ones you like best Mustang. That way you dont have to spend money on the stripes if you dont like the color.

snicksnipa

eeek a little too much plastidip, I like the fender stripes, not too sure about a big fat stripe down the middle

jlopez07

Ya i was hesitant about the hood stripe, but my hood is plain. Gb is one of those colors that too much looks horrible, but just enough looks good. I bought a Xenon scoop and just waiting to get it so I install it.

WildHorses67

the door sills is definately an unique look