Want to see supercharger dyno's!
#1
Want to see supercharger dyno's!
I'm trying to figure out which twin screw supercharger is the best. I want to get the most horsepower out of my stock engine as possible right now. Later on though I have plans to upgrade the internals and crank up the boost. Is the saleen still the best or should I go with the Whipple or Kenne Bell? I want to hear from people with superchargers and I want to see the dyno charts as well. Also I want to know exactly what you had to do to get those numbers. Thanks -Andrew
#3
RE: Want to see supercharger dyno's!
Here is my last KB run. It was on a hot engine with stock exhaust. The dyno guy said that I'm losing about 30hp with this exhaust (on a blown car). His opinion was that the Saleen was a smaller supercharger and probably more efficient at the power range that we are using (ie. do not need a blower capable of feeding an 800 HP engine).
[IMG]local://upfiles/35567/27655C2426114E5FA4F810287295528A.jpg[/IMG]
[IMG]local://upfiles/35567/27655C2426114E5FA4F810287295528A.jpg[/IMG]
#4
RE: Want to see supercharger dyno's!
Here's a video of my dyno after having 10lb pulley installed on my Saleen S/C. I've had the car dyno'd again and with a new TC and now putting out 420hp/390tq.
http://videos.streetfire.net/video/5...ba31173ad5.htm
http://videos.streetfire.net/video/5...ba31173ad5.htm
#7
RE: Want to see supercharger dyno's!
Yea yea yea... same excuse as everyone else. I don't have a current pull. But here is one with a 7.5lb pulley and a conservative street tune ( only 15 degrees of timing in this pull ).
[IMG]local://upfiles/13513/1930E8054C1E4189BEE67E6DECB4E885.jpg[/IMG]
I have since gone a little more radical on the pull, added some fuel system upgrades and switched to a 10lb pulley.
[IMG]local://upfiles/13513/1930E8054C1E4189BEE67E6DECB4E885.jpg[/IMG]
I have since gone a little more radical on the pull, added some fuel system upgrades and switched to a 10lb pulley.
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM