Flowmaster AT Installation
Hello all, hope this isn't too much of a repeat but I am going to be installing my Flowmaster AT systemtomorrow on my GT and I just wanted to make sure there wasn't anything in particular I should be aware of before I begin. It seems quite simple but I want to make sure that I don't screw anything up. Would it be possible to even mess up the engine or anything else when I do this? I highly doubt it but wanted to make sure. I know that for some CAI systems a tune is required. I assume no tune is required for the exhaust but I just want to make sure. Thanks in advance for your help. FYI, I will be putting the car up on ramps for this and don't intend to weld the system.
Thanks again. |
RE: Flowmaster AT Installation
If you can turn a wrench, you can install the Flows no problem. You do not need a CAI or a tune to use them - they are pretty much for the sound only (no real HP gains).
One thing you will probably run into is an alignment issue with the exhaust tips. To make it line up properly, do not bend the welded brackets on the muffler - adjust it by working with the mid-pipe clamps in the middle of the car. |
RE: Flowmaster AT Installation
Thanks for the info, that's exactly what I wanted to hear!
How do you like yours? |
RE: Flowmaster AT Installation
https://mustangforums.com/m_3104526/tm.htm
Awesome howto guide for the stingers but it is the same for any axle back. |
RE: Flowmaster AT Installation
+1. that is a great write up. only thing that might be a pain in the butt is getting to the one hangar up behind the quarter pannel. also make sure that you slide the muffler all the way back so they both are even, so your mufflers dont look cockeyed haha. it should take u more than an hour tho. mayb 1.5hr
|
RE: Flowmaster AT Installation
so would a single flowmaster AT bolt on to a 4.0 mustang?
|
RE: Flowmaster AT Installation
im not sure if they are exactly the same. they make one for the 4.0. but im not sure if the piping of the gt is the same size as the 4.0.
|
RE: Flowmaster AT Installation
waite actually yes it would. if a gt takeoff can fit a v6 then that will work too.
|
RE: Flowmaster AT Installation
so wheres the best place to buy one from. I seen them on thepartsbin.com but it said universal fit, so i dont know if that would bolt on.
|
RE: Flowmaster AT Installation
if u have one get it from a local performance shop. if not i think americanmuscle.com has them, aswell as v6mustangstuff.com. or EBAY, your best friend
|
All times are GMT -5. The time now is 09:08 PM. |
© 2024 MH Sub I, LLC dba Internet Brands