C&L Intake - 17RWHP
#1
C&L Intake - 17RWHP
http://www.bamachips.com/store/index...7c87bdee263049
Well, I was looking at a new tune and spotted this. $800 dollars for what would appear to be a net gain of 7 rwhp. This will be one for the higher HP cars. I was secretly hoping for more.
The delete plates are supposted to be good for 10rwhp and if this intake has them "built" in then it looks like a very small gain on a minor bolt on car. Which is what C&L did put out there from the start.
Well, I was looking at a new tune and spotted this. $800 dollars for what would appear to be a net gain of 7 rwhp. This will be one for the higher HP cars. I was secretly hoping for more.
The delete plates are supposted to be good for 10rwhp and if this intake has them "built" in then it looks like a very small gain on a minor bolt on car. Which is what C&L did put out there from the start.
Last edited by tampa07gt; 01-08-2009 at 10:19 PM.
#2
A Roush Stg3 uses their roots blower, which replaces the intake manifold completely making that C&L intake un-useable.
I think this intake is probably intended for either a centri blower, turbo setup, or a engine that has been bored over.
I think this intake is probably intended for either a centri blower, turbo setup, or a engine that has been bored over.
#3
I removed that last part to save myself any further shame
I agree, really for heavy mod cars. With Brenspeed selling a S/C for $3700 forced induction is still the way to go.
#5
I had high hopes for this mod, hopefully we'll see better gains than that...like in the 25rwhp range. I have full bolt ons and cams, so perhaps I can see that number. Then again, I already have CMDPs so thats ~7rwhp less right there.
I may end up with ported heads before then, but I definitely want to see better gains before I throw away $800.
I may end up with ported heads before then, but I definitely want to see better gains before I throw away $800.
#7
I had high hopes for this mod, hopefully we'll see better gains than that...like in the 25rwhp range. I have full bolt ons and cams, so perhaps I can see that number. Then again, I already have CMDPs so thats ~7rwhp less right there.
I may end up with ported heads before then, but I definitely want to see better gains before I throw away $800.
I may end up with ported heads before then, but I definitely want to see better gains before I throw away $800.
P.S. What hood is that. Killer!
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
daltron
5.0L GT S550 Tech
17
04-28-2016 08:10 PM
bradleyb
Classic Mustangs (Tech)
3
11-27-2015 07:50 PM