5SPD07GT

how does it secure to the under side of the trunk lid? I want to make a piece to cover the underside of the trunk for car shows etc to cover up the dynamat. I have 1/4 mdf board i am going to use but i'm unsure on how to secure it to the trunk lid.

eddypython

I used these

and covered them up with carpet that I used to cover by woofer box, used the holes that are in the trunk lid allready. and put some heavy duty double sided tape on the raised ridges of the trunk lid

eddypython

here's a pic

5SPD07GT

thanks, thats exactly what i was looking to do. did you use 1/4in mdf? and where did you get those white clips?

odiaz

I used door panel fasteneres like these:

http://www.technologylk.com/ImageVie...roduct_ID=8018

They go on the board before you upholster it so that you don't see any screw heads.

eddypython

I bought them from home depot. they are like $ 1.40 for a bag of 6 or something like that. I used thick cardboard.

5SPD07GT

where did you get them? auto zone? and what kind of board did you use? thanks man

5SPD07GT

anyone? couldnt find them at home depot

Va. Stang

Go to auto zone or pep boys and buy the black trim push retainers. They have about a 3/4 inch head with a ribbed shank. cut some of the deck lid cloth and apply over the trim retainer head to keep it from showing in the front.

5SPD07GT

have you made one? if so, what materail did you use? i think i need to find something thinner than the 1/4 mdf. Thanks