Gt500 Pump installed- Fuel Gauge error
#1
Gt500 Pump installed- Fuel Gauge error -SOLVED
Hey guys,
Managed to put on the GT500 Fuel pump. Completed th install, the car runs fine, however about 10 secs after I start the car the fuel goes to empty and I get a low fuel error followed by DTE FLI DATA ERROR. I suspect I may have connected something backwards. Anyone?
*****Read up to the second page. Problem solved******
Managed to put on the GT500 Fuel pump. Completed th install, the car runs fine, however about 10 secs after I start the car the fuel goes to empty and I get a low fuel error followed by DTE FLI DATA ERROR. I suspect I may have connected something backwards. Anyone?
*****Read up to the second page. Problem solved******
Last edited by vasman; 08-19-2009 at 09:41 PM. Reason: Solution Found!
#4
Stock LB/Yl lines up with New harness LBYL
Stock LG/VT lines up with New harness LG/VT
Black and pink left on the old connector and hanging.
#5
You shouldn't have any pins left behind on the old connector.
On the new 6-pin connector:
Black wire to Pin 1
Light Blue/Yellow to Pin 2
Pink/Black to Pin 4
Light Green/Purple to Pin 5
2 whites should have come already on the new 6-pin in pin 3 and 6. You have to keep them in place or remember where they went.
Hope that helps.
On the new 6-pin connector:
Black wire to Pin 1
Light Blue/Yellow to Pin 2
Pink/Black to Pin 4
Light Green/Purple to Pin 5
2 whites should have come already on the new 6-pin in pin 3 and 6. You have to keep them in place or remember where they went.
Hope that helps.
#6
My setup looks pretty much like this pic from the how to's in this forum. red and black left hanging. The only difference is that the wires from the new harness to the modified connector are the LG and LB instead of Black and pink as they seem to be in this picture.
http://i172.photobucket.com/albums/w...all/d055-1.jpg
http://i172.photobucket.com/albums/w...all/d055-1.jpg
#7
My setup looks pretty much like this pic from the how to's in this forum. red and black left hanging. The only difference is that the wires from the new harness to the modified connector are the LG and LB instead of Black and pink as they seem to be in this picture.
http://i172.photobucket.com/albums/w...all/d055-1.jpg
http://i172.photobucket.com/albums/w...all/d055-1.jpg
#8
My setup looks pretty much like this pic from the how to's in this forum. red and black left hanging. The only difference is that the wires from the new harness to the modified connector are the LG and LB instead of Black and pink as they seem to be in this picture.
http://i172.photobucket.com/albums/w...all/d055-1.jpg
http://i172.photobucket.com/albums/w...all/d055-1.jpg
#10