Getting tierd of C&L rubbing
#1
Getting tierd of C&L rubbing
I had my C&L Racer intake installed by Tillman speed, and it was not put in right because the filter was rubbing against the bottom part. After replacing the rubbed filter with a replacement, and re-adjusting the whole tube myself it's now rubbing against the bottom part of that plastic cover. Also the top of the plastic cover over the filter is rubbing against the Mass Air Flow sensor and the plastic cupplet is rubbing against the (I think it is) the power steering. All mentioned above have visable tear downs, and the filter is wearing down again too......
Was the C&L Racer intake meant to fin an 09 GT??????????????????????????????
Was the C&L Racer intake meant to fin an 09 GT??????????????????????????????
Thread
Thread Starter
Forum
Replies
Last Post
ccdguy
5.0L (1979-1995) Mustang
1
09-19-2015 05:20 PM
MustangVixenGT
V6 (1994-2004) Mustangs
8
09-16-2015 04:16 PM