PUTTING ON LONGTUBE HEADERS
#1
PUTTING ON LONGTUBE HEADERS
I have a question I already have a off road prochamber on my car, but now I want to put long tube headers in when I go for my cam's will my prochamber bolt up to the headers or will I have to purchase a new mid pipe. I was told the prochamber will not work the bbk's so I would either need a off road h or x pipe, if anyone can let me know about what I can do I would appreciate it thanks.
#2
LT's will require a short midpipe.
midpipe for shorty's or stock manifolds will not work.
if you are getting BBK LT's, you should get the BBK short mid pipe that matches the LT's.
i also have the BBK LT's and o/r x pipe. good LT's for the money. ceramic coated is good too.
midpipe for shorty's or stock manifolds will not work.
if you are getting BBK LT's, you should get the BBK short mid pipe that matches the LT's.
i also have the BBK LT's and o/r x pipe. good LT's for the money. ceramic coated is good too.
#7
#9
If you like your prochamber you can go with Mac long tubes and the shorty prochamber. After all they were the best performing headers and there resonably cheap.
http://www.brenspeed.com/20546.html
http://www.brenspeed.com/pc4605.html
http://www.brenspeed.com/20546.html
http://www.brenspeed.com/pc4605.html
Last edited by JDWalton; 10-28-2010 at 09:01 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM