Here is my axle

Reply Subscribe

Thread Tools

Search this Thread

01-15-2012, 11:47 PM

#11

defiance

3rd Gear Member

Join Date: Apr 2008

Location: South Carolina

Posts: 818

I believe you will have to get a new flange that has a flat face so to speak. The cupped one will not work.

01-16-2012, 02:25 PM

#12

up_yours_7

3rd Gear Member

Thread Starter

Join Date: Dec 2007

Location: Tooele, Utah

Posts: 667

Bought the new flange from rock auto now wait till Friday to get it

01-16-2012, 02:31 PM

#13

Stang-aholic

4th Gear Member

Join Date: Aug 2008

Location: FL

Posts: 1,173

ill warn you to be careful when installing the new flange, there is a crush sleve in there when you preload (tighten) it down make sure not to over/under do it or wiggle the thing around too much it may loosen the sleve

01-16-2012, 02:48 PM

#14

up_yours_7

3rd Gear Member

Thread Starter

Join Date: Dec 2007

Location: Tooele, Utah

Posts: 667

Ya I have read a lot about that not to torque it above 150 ftlb

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

What other parts should I be concerned about if my pinion bearing went bad?

KingRando

2005-2014 Mustangs

10-02-2015 08:06 AM

Car Suspension problems?

marc954

4.6L (1996-2004 Modular) Mustang

09-29-2015 11:18 AM

2 or 4 wheel alignment?

lincolnshibuya

V6 (1994-2004) Mustangs

09-24-2015 10:46 PM

Steeda S550 Mustang GT Axle-Back Exhaust with Aftermarket H-pipe (15-16 GT)

tj@steeda

Steeda Autosports

09-24-2015 09:18 PM

Steeda's S550 Mustang GT Axle-Back Exhaust System - Video Inside

tj@steeda

Steeda Autosports

09-10-2015 08:39 PM