Driveline vibration 1-piece DS and how did you correct?
#1
Driveline vibration 1-piece DS and how did you correct?
The last little tick regarding my car is a slight vibration that begins at 70-75 and worsens with speed. This is my second Coast aluminum shaft (the first came apart at the slip yoke). Hell, that could be the problem with this one. Word is, the slip yoke design isn't exactly a good one. I'd go with one of these expensive CF shafts if it would cure the problem.
http://www.vmptuning.com/store/index...=392&parent=97
My pinion angle is correct so I know that isn't the problem. Are there other CV joint design driveshafts or cheaper options out there?
Also, any thoughts on what you did to alleviate the vibration is appreciated.
Thanks.
http://www.vmptuning.com/store/index...=392&parent=97
My pinion angle is correct so I know that isn't the problem. Are there other CV joint design driveshafts or cheaper options out there?
Also, any thoughts on what you did to alleviate the vibration is appreciated.
Thanks.
#2
I do believe DSS makes DS with CV joints at the back, I think the aluminum shafts are around $700
Will this fit your car?
http://www.lethalperformance.com/07-...aft-900hp.html
Will this fit your car?
http://www.lethalperformance.com/07-...aft-900hp.html
Last edited by WORKISSLOW; 07-25-2012 at 06:42 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
2.3L Eco-Boost Tech
2
11-24-2015 06:11 AM