slickman

I'm looking for picture of the back and underside of the hood scoop and air box , Can anyone help me out? I'm going to modify one to work with an Edelbrock SuperCharger. Any help would be grate.

I have an extra hood to use for fab work so, I'm not worried about filling extra hole or anything.

aircare84

Closest pic I have of the rear. Side shot of my Shaker on my 06 GT. I had trimmed the shroud down quite a bit. Sorry, but no underside pics.

slickman

So, the cold are section goes over the intake not behind it? Why did you have to trim the rear section of the shroud?

07GrabU

Most likely because all that plastic looks horrible and if you put any time and cash into painting/buying powder coated valve covers you wanna show them off

aircare84

I didn't have to trim the rear of the shroud. I trimmed off the sides & front, mainly because I didn't like all the plastic. Attached a few more pics before I trimmed & also showing the duct to the CAI.
I did end up powder coating the valve covers at a later date as well.
The bottom of the SHaker attached to the front top 2 studs of the throttle body in the front & with a 'ball' stud in the rear (Bolted onto the existing factory intake manifold)

slickman

Thanks for the pics! I have a friend thats giving me a hood to use so i can leave mine stock. I can get the shaker hood setup for $500. Paint will cost me $500. So just looking at the process of making it work with a edelbrock super charger.