where is map/baro sensor 05 v6
#3
P0108 - Manifold Absolute Pressure (MAP)/Barometric Pressure (BARO) Sensor High
Description: Sensor operating voltage is greater than 5 volts (VREF). As a result it failed above the
maximum allowable calibrated parameter.
Possible Causes:
VREF shorted to VPWR
MAP signal shorted to VPWR
VREF should be less than 6.0 volts. The PID reading is in frequency/volts
Open circuit
Diagnostic Aids:
VREF should be greater than 4.0 volts. The PID reading is in frequency/volts.
Description: Sensor operating voltage is greater than 5 volts (VREF). As a result it failed above the
maximum allowable calibrated parameter.
Possible Causes:
VREF shorted to VPWR
MAP signal shorted to VPWR
VREF should be less than 6.0 volts. The PID reading is in frequency/volts
Open circuit
Diagnostic Aids:
VREF should be greater than 4.0 volts. The PID reading is in frequency/volts.
#6
NO, NO, No!!! the MAP sensor in a V6 is attached into the EGR module. Make sure the plug is connected to the egr module and the wires are not nicked or chewed through.
The MAP sensor can go bad and throw an appropriate code (mine did).
(The V8's have no MAP sensor; "MAP" gets inferred by the v8 pcm).
The MAP sensor can go bad and throw an appropriate code (mine did).
(The V8's have no MAP sensor; "MAP" gets inferred by the v8 pcm).
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
TfcCDR
V6 (1994-2004) Mustangs
1
09-14-2015 12:08 PM