Control Arm Questions
#12
#14
hahah, I hadn't looked under 2009 until after I posted and then never corrected it. Thanks. Sill almost 400 for the two of them when my stock ones lasted almost 10 years. And only one needs replaced.
#15
http://www.tascaparts.com/control-ar...rade/m-3075-e/
#16
I purchased a set (GT500) from Tasca a couple years ago for ~$200, they have gone up a little, but still a lot cheaper than $400.
http://www.tascaparts.com/control-ar...rade/m-3075-e/
http://www.tascaparts.com/control-ar...rade/m-3075-e/
And, the listing says GT, not GT500. How do we know these are not just the stock GT ones?
#17
From the Description. It fits the GT but was OE on the GT500.
The ball joint item is the important one.
Norm
Product Description
Fits 2005-2010 Mustang GT built on or before 8/3/09 with 18mm ball joint shaft
Original equipment on 2007-2009 Shelby GT500
Increased strength ball joints
Kit contains 1 RH and 1 LH lower control arm assembly
NOTE:Some factory fasteners are one time use. Please reference a Ford service manual for reuse information and correct torque specifications.
Fits 2005-2010 Mustang GT built on or before 8/3/09 with 18mm ball joint shaft
Original equipment on 2007-2009 Shelby GT500
Increased strength ball joints
Kit contains 1 RH and 1 LH lower control arm assembly
NOTE:Some factory fasteners are one time use. Please reference a Ford service manual for reuse information and correct torque specifications.
Norm
#18
"Fits 2005-2010 Mustang GT built on or before 8/3/09 with 18mm ball joint shaft
Original equipment on 2007-2009 Shelby GT500
Increased strength ball joints
Kit contains 1 RH and 1 LH lower control arm assembly"
Has correct part number listed: M-3075-E
From another site, same part number:
"Fits 2005-2009 V6 built on or before 2/26/09 with 18mm ball joint shaft.
Fits 2005-2010 GT built on or before 8/3/09 with 18mm ball joint shaft.
Fits original 2007-2009 GT500."
Someone correct me if I am wrong, but I believe the V6 & GT use the same control arms stock. These work on my car and I have a 2007 V6.
#19
Well my mustang is before 2/26/09, but are they starting there was an option to have something other than an 18mm ball joint shaft, or are they just providing that information?
I guess I could call them later today, but I would like someone here to confirm.
I guess I could call them later today, but I would like someone here to confirm.