AAC Halo's on 2011 Mustang.
#1
AAC Halo's on 2011 Mustang.
I bought some Headlight Halo's for my new Mustang. Finally got around to installing them a few days ago.
They were a complete B!TCH to install! Getting all the glue removed after prying the headlights apart sucks.
The worst part was finding out that AAC gave me the wrong halos! I called them and after around 30 minutes of on hold/off hold, someone told me how to trim them myself.
I also had to make some aluminum rings to install the halo's into the lights. I am not sure if they correct ones for the '10-11 Mustangs are easier, but these sucked! I would NOT do this mod again!
EDIT 7/8/2011
Here are photos of the light apart and LED Halo Ring 3M taped in:
Here is how I went around curing the RTV after finishing the install:
They were a complete B!TCH to install! Getting all the glue removed after prying the headlights apart sucks.
The worst part was finding out that AAC gave me the wrong halos! I called them and after around 30 minutes of on hold/off hold, someone told me how to trim them myself.
I also had to make some aluminum rings to install the halo's into the lights. I am not sure if they correct ones for the '10-11 Mustangs are easier, but these sucked! I would NOT do this mod again!
EDIT 7/8/2011
Here are photos of the light apart and LED Halo Ring 3M taped in:
Here is how I went around curing the RTV after finishing the install:
Last edited by brimy311; 07-08-2011 at 01:37 PM.
#10
Yes, you have to remove the front bumper to get the headlights out. From start to finish, I had the car apart for around 6 hours. Most of the time is spent heating the lights in the oven, prying them apart, heating them, prying some more and such.