StreetGhost

Alright, I am at this cross-roads right now...

ROUSH Rear Valance

or

GT500 Rear Valance

I am going to order the RTR front chin/splitter and roush side splitters this week and I am tossing which rear valance to put with it. Which one do you guys think goes with the RTR front and roush sides the best? I am thinking the roush but I am not sure....

Also, Where is the best/cheapest place to get either part from? Latemodelresto has the roush for $175 but I am sure there are better prices out there...

(sorry, don't know how to do a poll or I would)

facacc

you could do the RTR rear with the splitters. its a gt500 with some added bits. I did the roush and now wish I wouls have gone with it instead.

StreetGhost

No, I am not wanting to spend the $500+ on a rear valance when the Roush is $175+/- and the GT500 is $150+/-

grabber blue gt

I personally like the gt500 much better. IMHO the roush just doesnt flow right

wilkinda

The Roush if your getting the square tips to properly fit the opening. Otherwise the GT500 if the tips are round. The square opening of the Roush just looks odd with round tips. I am not sure if the Roush square tips are available for the 2010. I know they are for the 2011+

CJStang50

IMO I don't like putting any GT500 ground effects on a non-Shelby 'Stang. I run the Roush. Here's how it looks


IMG_0497 edited resized by MJ23FE, on Flickr


IMG_0462 edited resizsed by MJ23FE, on Flickr


IMG_0493 edited resized by MJ23FE, on Flickr


IMG_0503 edited resized by MJ23FE, on Flickr


IMG_0481 edited resized by MJ23FE, on Flickr

JimmyM

Roush only if you go square tips imo

StreetGhost

Just ordered the RTR Front Chin/Splitter, RTR Side Splitters, and Roush Rear Valance!!

CJStang50

Good man, you'll be happy with your choice.

discodave

Tips are tips and you can make them fit on any model year. It just depends on what you're looking for. Here is my Roush rear. The GT500 one is nice too, but my pick was the Roush. I also like the Roush rear spoiler also, so decided to go with both: