make up my mind for me
#1
make up my mind for me
I need help concerning a 408Imbuilding well collecting really. I am ready to buy the rotating assembly. But I need some advise on what comp ratio to run it at. I am not sure about the cam either. This is a weekend warrior street car so it can be a nasty engine. I would like to run it on 93oct and was leaning towards a 11-1 ratio. I have the following dart iron eagle 351 block, dart cnc 225 heads,jesel comp rockers, and a super victor intake. Please help me decide.
#2
RE: make up my mind for me
What do your combustion chambers measure on your heads? That goes in the way of determining what your finish comp. ratio is going to be. Common ration is 10.5:1, and I run with a guy running non-pump gas running 12:1 naturally aspirated of course. I have stayed below 11:1 and my next project will be a 9:1 blower motor.
Cam selection you would do good in speaking with somebody about a custom grind based on compression ratio, fuel delivery system, if you are going to run an automatic then stall speed plays a part along with rear end ration. A good shop can nail your cam chopice dead nuts.
P/M if you need links. also look for FullAuto on here, I have gotten good feedback about his prices and products.
Cam selection you would do good in speaking with somebody about a custom grind based on compression ratio, fuel delivery system, if you are going to run an automatic then stall speed plays a part along with rear end ration. A good shop can nail your cam chopice dead nuts.
P/M if you need links. also look for FullAuto on here, I have gotten good feedback about his prices and products.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM
Insidian
Carolina Regional Chapter
11
09-08-2015 05:33 AM
mungodrums
Suspension
0
09-07-2015 07:22 PM