Rear Axle & Driveshaft installation, Pinion Pre-load?
11-22-2009, 05:29 AM
1st Gear Member
Join Date: Sep 2009
Location: Arkansas
Posts: 96
Thank you Jim, for the confirmation.
11-22-2009, 04:58 PM
Moderator
Join Date: May 2006
Location: Michigan again!
Posts: 8,579
You're welcome. I forgot to say that the ebrake relocation is also only if you have lowered the car. My driveshaft went right in with no problems.
11-25-2009, 06:54 PM
4th Gear Member
Join Date: Feb 2007
Location: Va Beach
Posts: 1,069
Quote:
Originally Posted by
Fred Malibu
I keep dreaming about the 8'8 rearend.. and I realize I dont have $1000 to spend
LOL....I know the feeling. I'm in the same boat myself.
11-26-2009, 07:27 AM
Moderator
Join Date: May 2006
Location: Michigan again!
Posts: 8,579
Quote:
Originally Posted by
Fred Malibu
I keep dreaming about the 8'8 rearend.. and I realize I dont have $1000 to spend
Quote:
Originally Posted by
bronxbomba63
LOL....I know the feeling. I'm in the same boat myself.
What gear set are you looking for? I can probably get a rear end shipped to you for a lot less than $1,000
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
drfister
2005-2014 Mustangs
11
05-03-2018 10:38 PM
Urambo Tauro
5.0L (1979-1995) Mustang
22
09-07-2015 12:47 PM
whatsup62
5.0L GT S550 Tech
0
08-29-2015 01:25 PM
Urambo Tauro
5.0L (1979-1995) Mustang
9
08-27-2015 10:53 AM
prophotog
Classic Mustangs (Tech)
10
08-26-2015 11:55 AM
2007 ,
88 ,
axel ,
cost ,
drive ,
driveline ,
driveshaft ,
end ,
install ,
mustang ,
pinion ,
preload ,
rear ,
shaft ,
v6