Running wires
#1
Running wires
Hi there I need to run one ground from a relay under the hood into the cabin, but I don't want to have to make a hole in the firewall to do it.
So my question is whats the best way to run a wire from a foglight relay into the cabin? I was going to use this method
This guy mentions removing the drivers side fender, but I'm not sure where these screws would be located. Is this a good method to use?
So my question is whats the best way to run a wire from a foglight relay into the cabin? I was going to use this method
This guy mentions removing the drivers side fender, but I'm not sure where these screws would be located. Is this a good method to use?
#2
You remove the inner fender liner and the plastic fasteners are pretty obvious so you should not have a problem. Its pretty much the only option if you don't want to drill a new hole in the firewall..
Thread
Thread Starter
Forum
Replies
Last Post