Broken stud in exhaust manifold
#1
Broken stud in exhaust manifold
Hey all... so I have. 4.0 2005 v6. I was replacing the exhaust manifold gasket on the drivers side last night and as I was just double checking to make sure that I had tightened all of the studs in properly, when one of the studs snapped right in front of the shoulder with the rest of the stud still tightened into my manifold/block. I’m really concerned about getting it out as I don’t have an angle drill, and there’s no chance of me lifting the car or pulling the engine. Any advice? Thanks I’m advance.
#2
Hey all... so I have. 4.0 2005 v6. I was replacing the exhaust manifold gasket on the drivers side last night and as I was just double checking to make sure that I had tightened all of the studs in properly, when one of the studs snapped right in front of the shoulder with the rest of the stud still tightened into my manifold/block. I’m really concerned about getting it out as I don’t have an angle drill, and there’s no chance of me lifting the car or pulling the engine. Any advice? Thanks I’m advance.
Thread
Thread Starter
Forum
Replies
Last Post
HACKGT350
4 Cylinder NA and Turbo
0
08-12-2006 06:25 PM