2006 V6 will not rev past 5000
11-30-2018, 04:25 PM
#1
Thread Starter
Join Date: Nov 2018
Location: Nebraska
Posts: 1
2006 V6 will not rev past 5000
A few weeks ago my CEL turned on, I had a look at it and it threw out P0300, ended up changing spark plugs and wires, witch seemed to make it go away, and ran fine for a week or two.
The problem now it that when I floor it, the revs start climbing and once they get to about 4500 it starts to slow down and will not go any further than 5000,
and if i keep the revs held there for a few second in 3rd gear the check engine light will start to flash but once I get it back down towards 40mph it will turn off completely.
I've read around on threads for similar issues but haven't found anything just like this. Does anyone know what my problem could be or where I should start looking?
The problem now it that when I floor it, the revs start climbing and once they get to about 4500 it starts to slow down and will not go any further than 5000,
and if i keep the revs held there for a few second in 3rd gear the check engine light will start to flash but once I get it back down towards 40mph it will turn off completely.
I've read around on threads for similar issues but haven't found anything just like this. Does anyone know what my problem could be or where I should start looking?
12-01-2018, 11:40 PM
#3
3rd Gear Member
Join Date: Jul 2017
Location: AZ
Posts: 849
Limp mode? At 5000 rpm? My understanding of limp mode is the code expressing "Forced Limited Power", which means just that......depress the gas pedal, little response, transmission shifts jerky, unpredictable......
Thread
Thread Starter
Forum
Replies
Last Post
