Cobra rods and pistons into GT
#1
Cobra rods and pistons into GT
If I were to put 99-01 cobra rods and pistons in a 2000 gt, would it be able to hold up to 300rwhp N/A setup? Also what would the compression be with these pistons? If I were to put xe270ha cams in, would something need to be done to the pistons to make sure the valves won't hit them?
Thanks
Thanks
#2
RE: Cobra rods and pistons into GT
ORIGINAL: b16coupe
If I were to put 99-01 cobra rods and pistons in a 2000 gt, would it be able to hold up to 300rwhp N/A setup? Also what would the compression be with these pistons? If I were to put xe270ha cams in, would something need to be done to the pistons to make sure the valves won't hit them?
Thanks
If I were to put 99-01 cobra rods and pistons in a 2000 gt, would it be able to hold up to 300rwhp N/A setup? Also what would the compression be with these pistons? If I were to put xe270ha cams in, would something need to be done to the pistons to make sure the valves won't hit them?
Thanks
#3
RE: Cobra rods and pistons into GT
ORIGINAL: 2000GT4.6
They arn't any better than your stock stuff....
ORIGINAL: b16coupe
If I were to put 99-01 cobra rods and pistons in a 2000 gt, would it be able to hold up to 300rwhp N/A setup? Also what would the compression be with these pistons? If I were to put xe270ha cams in, would something need to be done to the pistons to make sure the valves won't hit them?
Thanks
If I were to put 99-01 cobra rods and pistons in a 2000 gt, would it be able to hold up to 300rwhp N/A setup? Also what would the compression be with these pistons? If I were to put xe270ha cams in, would something need to be done to the pistons to make sure the valves won't hit them?
Thanks
#4
RE: Cobra rods and pistons into GT
ORIGINAL: code3GT
+1
ORIGINAL: 2000GT4.6
They arn't any better than your stock stuff....
ORIGINAL: b16coupe
If I were to put 99-01 cobra rods and pistons in a 2000 gt, would it be able to hold up to 300rwhp N/A setup? Also what would the compression be with these pistons? If I were to put xe270ha cams in, would something need to be done to the pistons to make sure the valves won't hit them?
Thanks
If I were to put 99-01 cobra rods and pistons in a 2000 gt, would it be able to hold up to 300rwhp N/A setup? Also what would the compression be with these pistons? If I were to put xe270ha cams in, would something need to be done to the pistons to make sure the valves won't hit them?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post