finshed engine and test drove
#1
finshed engine and test drove
just finished my 2valve project. the car is a 1997 gt. with steen racing ported pi heads. stage 3 crower cams. probe rods. cobra pistons. stock crank. aluminum block. tubular front end 4.30's. and some other stuff. i am still running my air conditioning too. mac longtubes with prochamber. should put down 325rwhp n/a. and run 11'80's but we will c next week.
#7
RE: finshed engine and test drove
hopefully steen can get my car finished. i was planning on staying n/a but i told them to put in the forged cobra block and blower cam i had them build since i spun a rod bearing on the mach block. good #'s thats what i was looking for with the bullitt swap.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
Steeda Autosports
0
09-01-2015 08:16 PM