Dan04COBRA

A 315/35/17 on a 17x10.5 wheel on a Cobra will fit without rolling fender lips, correct?

I need to purchase some rear tires for inspection in the next week.

droptoppony

This is a joke right? Or are serious you want to put a 315 on a 9 inch wheel...

Dan04COBRA

Yeah sorry thats supposed to be a 10.5 up there.

geetee03

my buddie had 315 bfg dr's on his stock rim (04 cobra). he had to shave a bolt a little bit but they did fit.

droptoppony

haha yeah thats a big difference...but i have seen guys ask it before..

Dan04COBRA

I'm looking to buy a new set of wheels & tires & putting my BFG drag radials on my stock wheels.

MustangMan00

no midifications needed for 315/35/17 on a 10.5 rim

rbstang

jon has 315s on 17x9 cobra rims...

Aixtreme89

I have a friend with a 03 cobra. He had to get 295/35/R17 wheels on his. Because he says there is a bolt on the independent suspension that will hit the tire otherwise. I have read somewhere that you can grind the bold down or get a smaller bot of something. But I think you can only fit 295's. I have 315s on my car, I have a solid axle though. But as much as everyone says you dont need modifications. My tires scrape the fenders, not all the time, just when I am going up and entrance of a store or something where the axle rocks from one side to the other. And when I am carring things in my trunk and go over bumps on the highway I can hear my tires hit my fender. Or when I am very aggresive driving it hits. I need to roll my fender eventually. But I have goodyear Eagle F1's and they run wide for a the 315

[IMG]local://upfiles/12416/100A0B291F71431A8E873793D61D8CA2.jpg[/IMG]

04BlueGT

^ What he said. Code had 335s in the back and said he didn't have to roll the fenders, but it had to be close.