96 gt pi intake swap - MustangForums.com

4.6L (1996-2004 Modular) Mustang Technical discussions on 1996-2004 4.6 Liter Modular Motors (2V and 4V) within.

96 gt pi intake swap

Reply

 
 
 
Old 10-28-2006, 04:49 AM
  #1  
brenstang
1st Gear Member
Thread Starter
 
Join Date: Jul 2006
Location:
Posts: 67
Default 96 gt pi intake swap

im getting ready to swap intakes tomorrow, and just wanted to make a couple things clear.. because im putting a pi intake on the non pi motor i need to take off the water pump and put the pi oring on? My engine has only 45,000 so should i just replace the waterpump if im taking it off, i plan on selling the car in a few months... also on one site i read that the pi gaskets dont line up quite right with the pi heads and requires some trimming?? i dont actually have a whole lot to ask now but probly will tomorrow as im right in the middle of it .. can you please post some write ups you have or have found, ive been searching and trying to read them all.. thanks bren
brenstang is offline  
Reply With Quote
Old 10-28-2006, 01:32 PM
  #2  
sweet99
4th Gear Member
 
Join Date: Jun 2006
Location: New York
Posts: 1,178
Default RE: 96 gt pi intake swap

I think you need PI heads also. Mark
sweet99 is offline  
Reply With Quote
Old 10-28-2006, 01:34 PM
  #3  
brenstang
1st Gear Member
Thread Starter
 
Join Date: Jul 2006
Location:
Posts: 67
Default RE: 96 gt pi intake swap

no people have switched just the intakes, hince modular..
brenstang is offline  
Reply With Quote
Old 10-28-2006, 02:05 PM
  #4  
gt96stang
5th Gear Member
 
Join Date: Mar 2005
Location: Navarre, FL
Posts: 3,689
Default RE: 96 gt pi intake swap

I think you should do some more reading up on it before you actually start to try and tackle it...

CLICK HERE, that's a pretty good write-up about what all needs to be done.
gt96stang is offline  
Reply With Quote
Old 10-28-2006, 05:08 PM
  #5  
Rantheman
3rd Gear Member
 
Join Date: Feb 2006
Location:
Posts: 563
Default RE: 96 gt pi intake swap

the p.i. intake it almost a direct swap you can gain somewere around 18rwhp from the swap itself even more if you had a more direct port match betwen the npi heads and the p.i intake so good luck to you
Rantheman is offline  
Reply With Quote
Reply
 
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Vrooom
4.6L General Discussion
13
02-21-2016 05:25 PM
04stangman
2005-2014 Mustangs
4
09-17-2015 01:45 PM
EASTIDEE123
5.0L (1979-1995) Mustang
14
09-14-2015 03:52 PM
jaiidutch
Motor Swap Section
2
09-14-2015 10:29 AM
vintageaion
2005-2014 Mustangs
2
09-08-2015 10:45 AM

Forum Jump

Thread Tools
Search this Thread
Advertising
Featured Sponsors
Vendor Directory