BAD news again
#11
RE: BAD news again
ORIGINAL: Dsmfighter
You REALLY should have replaced those bolts. Everyone who's done cam swaps on modulars have told me that if the cam's your installing use torque-till-yield bolts you should replace them every time you back them off the cam. Yeah it's a few bucks out of your pocket, but it would have saved you money in the long run.
Sorry to hear the news though man. That really blows.
You REALLY should have replaced those bolts. Everyone who's done cam swaps on modulars have told me that if the cam's your installing use torque-till-yield bolts you should replace them every time you back them off the cam. Yeah it's a few bucks out of your pocket, but it would have saved you money in the long run.
Sorry to hear the news though man. That really blows.
When I did my pi swap, I didn't wanna spend that kind of money on studs, however; after my friends talked me into it, I went with it. The problem you had with your car is the same exact reason why they told me to get new ones.
Hope everything works out.
Thread
Thread Starter
Forum
Replies
Last Post
KingRando
2005-2014 Mustangs
5
10-02-2015 08:06 AM
MustangForums Editor
GT350 S550 Tech
1
09-29-2015 03:29 PM