ripper

Check this out
i got the motor below plus pi intake, aluminum flywheel, motor mounts, water pump, all new hoses, and installed for little over 6ooo
excuse the addy they e mailed my specs

10 Peach Street - Paterson, New Jersey 07503
973-684-1500 Fax: 973-684-1212
Toll-Free 1-800-422-6022

Steve Connington
4.6 P.I. engine components(specs)

Production 4.6 Romeo block, studded mains, bored and stress-plate honed .020( 3.571)
New factory Cobra steel crank
Eagle H-beam rods with ARP 2000 bolts
Probe 18cc dish forged piston (9.1:1)
Factory P.I. cylinder heads with 44cc chamber
Factory P.I. camshafts 192/184 duration @.050 .535/.505 lift
ARP head stud kit and MLS Fel-Pro head gaskets
Balanced rotating assembly +/- 1 gram

These are the additional parts and services featured on this engine.
Everything else is remanufactured to stock specs (bearing clearances etc…)

seems like alot of money but it was installed in a week, all i did was drop the car off lol
was it worth it?

oxfordgt

It sounds like it gonna cost alot for the machining up there so here is a good company http://www.promodularperformance.com/1996-2005.htm . I talked to the owner for almost 2 hours one day and he is very knowledgable. I think they offer the best shortblock for the $$$. It comes with ARP main studs and high volume oil pump on a block just like the MMR600 and the VT stock replacement.