Stangfreak2002

Ok I'm installing my vortech V2 SQ aftercooled with an accufab TB and Plenum 75 mm , 3.73 gears, Steeda boost pipe , Tri ax shifter, m/t drag slicks and magnapacks !!

I will get a SCT dyno Tune from Steeda Canada cause they are the only one in Canada to do this !!!!

What do you think ?

rtm

I can't give you a number, but I'm sure it will be fast.

It sounds like a well thought out set-up.


Todd

nanaki

somewhere between 1 second and 20 seconds

jdaniel

I would be guessing about 12.2 to 12.6 if you are running 8-10psi and you can hook up. Weather factors doesnt so much affect a FI engine as it does an NA engine. Let us know how you run.

mdvaldosta

What size pulley? And in all honesty even if we knew the exact hp your making it would be hard to guess because traction and driver skill play a very larger part in how fast you will run. Driver makes all the difference - in a 14 second car a good driver might only get a tenth or two over a poor driver, but in a 12 second car it could make even up to a full second difference.

Stinger

hehehe last time i guessed i was right on the button. Im gonna say 12.2 @ 112..

Stangfreak2002

It's a 3.33 pulley !!

mdvaldosta

Yea Im thinkin low low 12's maybe even 11's if you can hook and drive sicne you've got slicks.

BCisme

you need exhaust. bad!! there's a guy here with superchagred GT, bone stock he made 343 rwhp. with ful exhaust, and i think a TB and plenum, he's now making over 400 even. you havent listed any exhaust mods, so please do some. you are choking that motor. but yea, mid 12's is my guess.